Filter
Top Products
Black plate (64,1)
Notes
! You can matchthe clock to a time signal by
pressing MULTI-CONTROL.
— If the minute is00 to 29, the minutes are
rounded down. (e.g.,10:18 becomes
10:00.)
— If the minute is30 to 59, the minutes are
rounded up. (e.g., 10:36becomes 11:00.)
! Even when the sourcesare off, the clock dis-
play appears on thedisplay. Pressing CLOCK
when the sources andfeature demo are off,
turns the clock displayon or off.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Use MULTI-CONTROL to select FM step.
FM step appears in the display.
2 Press MULTI-CONTROL to select the FM
tuning step.
Pressing MULTI-CONTROL repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
Note
If seek tuning is performed in 50 kHzsteps, sta-
tions may betuned in imprecisely.Tune inthe sta-
tions with manual tuningor use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
– 1602 kHz allowable) to 10 kHz (530 – 1640
kHz allowable).
1 Use MULTI-CONTROL to select AM step.
AM step appears in the display.
2 Press MULTI-CONTROL to select the AM
tuning step.
Pressing MULTI-CONTROL repeatedly will
switch the AM tuning step between 9 kHz and
10 kHz. The selected AM tuning step will ap-
pear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Use MULTI-CONTROL to select
Warning tone.
Warning tone appears in the display.
2 Press MULTI-CONTROL to turn warning
tone on.
ON appears in the display.
# Toturn warning tone off,press
MULTI-CONTROL again.
Switching the face auto open
For theft protection, the front panel opens
automatically and easily detaches. Face auto
open is on as a default.
1 Use MULTI-CONTROL to select
Face auto open.
Face auto open appears in the display.
2 Press MULTI-CONTROL to turn the face
auto open on.
ON appears in the display.
<CRD4082-A/N>64
Initial Settings
En
64
Section
12