Filter
Top Products
Black plate (10,1)
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to selectthe equalizer.
DYNAMIC—VOCAL—NATURAL—CUSTOM
—FLAT—POWERFUL
3 Press M.C. toconfirm the selection.
TONE CTRL(equalizer adjustment)
! Adjusted equalizercurve settings arestored in
CUSTOM.
1 Press M.C. todisplay the settingmode.
2 Press M.C. toselect BASS (bass)/MID(mid)/
TREBLE (treble).
3 TurnM.C. to adjustthe level.
Adjustment range:+6 to -6
LOUDNESS (loudness)
Loudness compensatesfor deficiencies inthe low-
and high-frequencyranges at lowvolume.
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to selectthe desired setting.
OFF (off)—LOW(low)—HIGH(high)
3 Press M.C. toconfirm the selection.
SUBWOOFER1 (subwooferon/off setting)
This unitis equipped witha subwoofer output
which canbe turned on oroff.
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to selectthe desired setting.
NORMAL (normalphase)—REVERSE (reverse
phase)—OFF (subwooferoff)
3 Press M.C. toconfirm the selection.
SUBWOOFER2 (subwooferadjustment)
The cut-off frequencyand output levelcan be ad-
justed whenthe subwoofer outputis on.
Only frequencieslower than thosein the selected
range areoutputted from thesubwoofer.
1 Press M.C. todisplay the settingmode.
2 Press M.C. tocycle between thecut-off fre-
quency andoutput level of thesubwoofer.
Cut-off frequency(Cut-off frequency display
flashes.)—Output level(Output level display
flashes.)
3 TurnM.C. to selectthe desired setting.
Cut-off frequency: 50HZ—63HZ—80HZ—
100HZ—125HZ
Output level:-24 to +6
SLA (sourcelevel adjustment)
SLA (SourceLevel Adjustment) letsyou adjust the
volume levelof each source toprevent radical
changes involume when switchingbetween sour-
ces.
! Settings arebased on theFM volume level,
which remainsunchanged.
! The AMvolume level canalso be adjusted with
this function.
! When selectingFM as thesource, you cannot
switch toSLA.
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to adjustthe source volume.
Adjustment range:+4 to –4
3 Press M.C. toconfirm the selection.
Initial Settings
1 Press and hold S(SRC/OFF) until the unit
turns off.
2 Press M.C. and hold untilfunction name
appears in the display.
3 Turn M.C. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
CLOCK SET(setting the clock)
1 Press M.C. todisplay the settingmode.
2 Press M.C. toselect the segmentof the clock
display youwish to set.
Hour—Minute
3 TurnM.C. to adjustthe clock.
AUX (auxiliary input)
Activate thissetting when usingan auxiliary de-
vice connectedto this unit.
1 Press M.C. toturn AUX onor off.
USB (plugand play)
This settingallows you toswitch your source to
USB/iPod automatically.
1 Press M.C. toturn the plugand play function
on oroff.
ON –When a USB storagedevice/iPodis con-
nected, dependingon the typeof device, the
source isautomatically switched to USB/iPod
when youturn on theengine. If you disconnect
your USBstorage device/iPod, this unit’s
source isturned off.
OFF –When a USB storagedevice/iPodis con-
nected, thesource is notswitched to USB/
iPod automatically. Pleasechange the source
to USB/iPodmanually.
SW CONTROL(rear output andsubwoofer set-
ting)
The rearspeaker leads outputand RCA output
can beused for full-range speaker orsubwoofer
connection.
If you switchto REAR-SP:SW,you can connecta
rear speakerlead directly toa subwoofer without
using anauxiliary amp.
Initially,REAR-SP isset for rear full-rangespeaker
connection (FUL).
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to changethe output and pressto
select.
REAR-SP—PREOUT
3 TurnM.C. to changethe setting.
REAR-SP:FUL—SW
PREOUT: SW—REA
! Even if youchange this setting,there will
be nooutput unless you turnthe sub-
woofer outputon (refer toSUBWOOFER1
(subwoofer on/off setting)on this page).
! If you changethis setting, subwooferout-
put inthe audio menuwill return tothe fac-
tory settings.
DEMO (demodisplay setting)
1 Press M.C. toturn the demodisplay on oroff.
SCROLL (scrollmode setting)
When everscroll is set toON, recorded textinfor-
mation scrollscontinuously in thedisplay. Setto
OFF ifyou prefer theinformation to scroll just
once.
1 Press M.C. toturn the everscroll on oroff.
BT CLEAR(resetting the Bluetoothwireless tech-
nology module)
Operating this unit
02
10
Section
Operating this unit
En
<YRD5324-A/S>10