Filter
Top Products
HANDLING CASSETTE TAPES
A _ Turn pencil to
remove tape slack
el
cl
For erasure prevention
remove
___ Tab for
__ Side A
Tab for
Side B
Cover with
adhesive tape
Erasure prevention tabs
i Sensor holes _l
TYPE IV (Metal) tape
Sensorl,__holes
TYPE il (High/CrO2) tape
JCHECK CASSETTE BEFORE USE ]
Check the following items before loading a cassette tape:
Is the tape loose, or is some of the tape outside the
cassette?
If some of the tape is loose or projecting outside the cassette shell,
the tape may not properly enter between the capstan and pinch
roller. This will prevent the tape from being supplied properly, and
may even damage the tape itself. In such cases, insert a pencil into
the reel hole and take up the slack (Fig. A).
Some cassette tapes come with a plastic or thick paper stopper
to prevent the tape from becoming slack. Remove this stopper when
loading the cassette and replace it after using the cassette.
Are the accidental erasure prevention tabs intact?
These tabs allow you to prevent important recordings from being
erased accidentally. When the tab on the cassette shell is broken
off (Fig. B), it is not possible to activate the recording function, so
valuable recordings will not be erased by mistake.
To rerecord on a cassette whose tab has been broken off, simply
stick a piece of doubled adhesive tape over the hole (Fig. C).
When using TYPE 1V (Metal) or TYPE !1 (High/CrO2) tapes, be
careful not to block the sensor holes with the tape (Fig. D, Fig. E).
If the holes are blocked, the automatic tape selector mechanism
will not operate correctly.
NO TES:
• The accidental erasure prevention tab for each side is the one
located on the top left when the side that you want to protect
is facing you.
• When breaking off the tab, do not use a magnetized screwdriver.
[ AUTOMATIC TAPE SELECTOR FUNCTION ]
This cassette deck is equipped with an automatic tape selector func-
tion which utilizes the sensor holes on the tape cassette to deter-
mine the type of tape being used. The deck is then set to match
the tape recording bias and equalization.
NO TES:
• When using TYPE IV (Metal) tapes, make sure that the tapes
have sensor holes.
• Make sure that the sensor holes on the cassette are not blocked;
otherewise the tape selector mechanism will not function
properly.
• Do not use TYPE I1! (FeCr) tapes.
I TIPS ON CASSETTE TAPES
I
• Leader tape (which cannot be recorded on) is provided at the
beginning of a cassette tape. Let the tape run for about 5 se-
conds before starting to record, to allow the leader tape to clear
the recording head.
• Do not leave a cassette tape exposed to the environment.
Store the cassette in its case after use so that dust and dirt
do not adhere to the tape, and so the tape will not get
slack. Store tapes in a location free from magnetism, dust,
dirt, oil, heat and humidity.
• Because C-120 tapes are very thin, they can easily jam in the
pinch rollers and capstan, and they often are subject to other
problems such as irregular winding. It is best not to use them
with this deck.
• If cassette tapes are irregularly wound, the tape may get jammed
in the rollers. This can cause damage to both the tape and the
deck. If you are not certain whether the tape is wound evenly,
fast forward or rewind the tape from beginning to end, to make
sure that the tape is properly wound.
5
<RRB1143_
En