Filter
Top Products
1)
The model number of the CLD-V2800 in response to ?X is P1537XX
2) If a picture stop code is recorded on currently playing CAV LaserDisc, the
player enters
Still Mode at the stop code point. If a picture stop is encountered
during a stop marker or auto stop segment play, an error message is returned. With
the new Picture Stop Command, Integer PS, picture stops can be disabled and
played through (1PS) or enabled (0PS).
3) If a frame specified by an auto stop or by a stop marker is missing, the player
enters Still Mode just beyond the specified frame.
4) When the CLD-V2800 is controlled by a computer, command execution may
sometimes be suspended if front panel buttons or remote control buttons are
pressed. To prevent this, use the Key Lock (KL) command to lock out front panel
and remote control input.
5) CLV frame mode (for CLV discs encoded with seconds) is available on the
CLD-V2800 by using the Frame Set (FR) command. See pages 3-21 and 3-18 for
details. CLV frame numbers do not appear on the front panel or on-screen display, but
can be verified by issuing the ?F command.
6) If the video area of a CDV has been recorded using the PAL system, sound only
will be reproduced when it is played on a CLD-V2800. (The disc is treated as a CD.)
7) The CLD-V2800 does not support the ?U command, allowing access to the
Standard User’s Code that may be encoded on LDs.
8) If a non-existent address is specified via computer control while a CD is playing,
an error code (E04) is returned. Users can access the CD’s Table of Contents (TOC) by
issuing the ?Q command via computer control. The following information is returned:
first track, last track, and total playing time (absolute time) of the CD. See Section
3.7.4 Request Commands, #38 TOC Information on page 3-34.
9) CDV playback begins from the video area. When the video playback is
completed, playback may end or the video may be replayed depending on how the
player’s Repeat Mode is set. When you want to play back audio, search for the track
you want to hear. When audio playback is completed, playback may end or the
audio may be replayed again, depending on the Repeat Mode.
10) During CD and CDV playback, if the stop marker is set to ±1 block from the
start point after a Pause, the player will not hold the stop marker.
11) During LD CLV playback, if the stop marker is set to ±1 frame, from the start
point after a Pause, the player will not hold the stop marker.
12) During CD playback, it is not possible to search for the absolute time address
0 minutes, 0 seconds, 0 block.
Laser Vision Player CLD-V2800 Level III User’s Manual/Programmer’s Reference Guide
TP 120 Version 1.0 10/95 Pioneer New Media Technologies, Inc.
© 1995 Pioneer New Media Technologies, Inc. All rights reserved. No part of this publication may be
reprinted or reproduced in any form without the permission in writing of the copyright holder.
CLD-V2800 Notes
Appendix E
CLD-V2800 Notes
TP 120 v. 1.0 • 10/95
E-1