23
OTHER (TROUBLESHOOTING/SPECIFICATIONS)
Error message display
When the CDJ-400 CD player is unable to operate properly, an error code is displayed on the display panel. Check the error code
displayed against the following table and take the recommended action to correct the error. If an error code other than any of the
error codes listed in the table below is displayed or if the same error code is displayed even after corrective action has been taken,
contact your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.
Error Code
E-72 01
E-83 01
E-83 02
E-83 03
E-83 04
E-83 05
E-91 01
Description
Player unable to read TOC data.
Disc is rotating, but rotation cannot be
ascertained.
Player unable to play back currently
inserted disc.
The disc loaded cannot be played
properly.
Mechanical operation has failed to
complete within specified time
interval.
Possible cause and recommended action
Disc is cracked.
= Recommended action: replace disc.
Disc is soiled or dirty.
= Recommended action: clean disc.
If other discs play normally, the problem is with
the disc itself.
The disc format does not conform to MP3.
= Change to disc conforming to MP3 format.
Dust or some other form of foreign particles have
found their way into disc insertion slot.
= Recommended action: remove dust or other
foreign particles.
Error Type
TOC READ ERROR
PLAYER ERROR
MP3 DECODE ERROR
DATA FORMAT ERROR
MECHANICAL TIME OUT
SPECIFICATIONS
1. General
System.............................. Compact disc digital audio system
Power requirements ....................................... AC 120 V, 60 Hz
Power consumption..........................................................17 W
Operating temperature ............. +5˚C to +35˚C (+41˚F to +95˚F)
Operating humidity ........ 5 % to 85 % (without condensation)
Weight ................................................................. 2.7 kg (5.8 lb)
Dimensions ....217.9 mm (W) × 107.5 mm (H) × 296.3 mm (D)
8.57 (W) × 4.23 (H) × 11.67 (D) in
2. Audio section
Frequency response........................................... 4 Hz to 20 kHz
Signal-to-noise ratio .......................... 115 dB or more (JEITA)
Distortion ......................................................... 0.006 % (JEITA)
3. Accessories
÷ Operating instructions........................................................ 1
÷ Power cord.......................................................................... 1
÷ Audio cable ......................................................................... 1
÷ Control cable....................................................................... 1
÷ Forced eject pin
(housed in a groove in the bottom panel) ......................... 1
÷ Limited warranty ................................................................ 1
÷ Screwdriver (housed in a groove in the bottom panel) .... 1
÷ Jog sheets (for replacing) .................................................. 3
NOTE:
Specifications and design are subject to possible modification with-
out notice.