Filter
Top Products
9
<ARE7263>
En
English
[ REAR PANEL ]
@ AC INLET jack
Connect power cord to here and an AC wall socket, or the AC
outlet of an audio timer.
If you are going to be away from home for a long period of
time, disconnect the unit from the wall socket.
NOTES:
÷
If you use an other power cord than provided, we cannot
assume the liabilities in what may occur as a result of it.
÷
(The provided power cord has a current capacity of 7 A.)
# AC OUTLETS
[SWITCHED TOTAL 100 W MAX]
Power supplied through these outlets is turned on and off by the
amplifier’s POWER ON/OFF switch. Total electrical power con-
sumption of connected equipment should not exceed 100 W.
[UNSWITCHED 100 W MAX]
Power flows continually to this outlet, regardless of whether the
amplifier is switched ON or OFF. Electrical power consumption of
the connected equipment should not exceed 100 W.
NOTES:
• Do not connect appliances with high power consumption
such as heaters, irons, or television sets to the AC OUT-
LETS in order to avoid overheating or fire risk. This can
cause the amplifier to malfunction.
• The equipment should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g. when on vacation.
TAPE 2 MONITOR
SIGNAL
GND
L
R
PHONO
IN
TUNER
IN
CD
IN
LINE/
SURROUND
BACK
IN
TAPE 1/CD-R/MD
REC PLAY REC PLAY
OUT INOUT IN
L
R
SPEAKERS
AC INLET
CONTROL
OUT
RL
R
A
B
L
ª · · ª
1 0 -
!~= @
AC 120 V 60 Hz
SWITCHED
TOTAL
100W MAX
UNSWITCHED
100W MAX
AC
OUTLETS
CAUTION:
DO NOT CONNECT
TV SET OR MONITOR.
ATTENTION:
NE RELIEZ PAS
AL'APPAREIL
DE TELEVISION
OU AU MONITEUR.
2 3 4 65 7 8 9
#
PANEL FACILITIES
1 GND (Turntable ground) terminal
2 PHONO terminals
3 TUNER terminals
4 CD terminals
5 LINE/SURROUND BACK terminals
6 TAPE 1/CD-R/MD REC (OUT) terminals
7 TAPE 1/CD-R/MD PLAY (IN) terminals
8 TAPE 2 MONITOR REC (OUT) terminals
9 TAPE 2 MONITOR PLAY (IN) terminals
0 SPEAKERS B terminals (Right channel)
- SPEAKERS B terminals (Left channel)
= SPEAKERS A terminals (Right channel)
~ SPEAKERS A terminals (Left channel)
! CONTROL OUT jack (see page 6)
This jack is for output of control signals when operating other
components bearing the Î mark with the attached remote
control unit.