Filter
Top Products
7
<ARE7263>
En
English
[ FRONT PANEL ]
PHONES
A SPEAKERS B
OFF ON
STEREO AMPLIFIER
_
—
z¿≤.B
TAPE 1/
CD-R/MD
TAPE 2
MONITOR
LINE
SB
TUNER
PHONO
CD
BASS
+
–
TREBLE
+
–
VOLUME
MIN MAX
SB MODE DIRECT
BALANCE
R
L
INPUT SELECTOR
TAPE 2
MONITOR
POWER
Î
~
1345
67890=-
2
Direct Energy MOS
REFERENCE STEREO AMPLIFIER
PANEL FACILITIES
1 POWER (— OFF/_ ON) switch
Press to turn power to the unit ON and OFF.
This unit cannot be turned ON and OFF using the remote
control unit.
2 REMOTE CONTROL SENSOR window
3 VOLUME control
Use to adjust the volume level.
4 INPUT SELECTOR knob/indicators
Turn the knob clockwise or counterclockwise so that the
indicator lights for your desired input source. Turning the knob
clockwise causes the lit indicator to right. Turning counter-
clockwise causes it to left.
CD : For compact disc playback with a CD player.
TUNER : For AM or FM broadcast reception with a
tuner.
PHONO : For record playback with a turntable.
LINE/SB : Set to this position when listening to the
program from a component connected to the
LINE/SURROUND BACK terminals.
TAPE 1/ : For playback with a cassette deck, CD
CD-R/MD recorder or MD recorder connected to TAPE1/
CD-R/MD terminals.
5 TAPE 2 MONITOR button/indicator
Use when there is an adaptor component (graphic equalizer,
etc.) or cassette deck connected to the TAPE2 MONITOR
terminals.
On : Indicator lights when using the adaptor component or
listening to the cassette deck.
Off : Indicator goes off when not in use.
NOTES:
÷
When no connections are made to the TAPE2 MONITOR
terminals, or when they are not in use, be sure to set this
switch to the off position. (No sound will be heard if it is set
to the on position.)
÷
When the TAPE2 MONITOR indicator is on and the INPUT
SELECTOR knob is not set to TAPE1/CD-R/MD, the signals
which are input through TAPE 2 MONITOR are then output
at TAPE1/CD-R/MD REC OUT.
6 BALANCE control
Should normally be left in the center position. Adjust balance
if the sound is louder from one of the speakers. If the right side
is louder, turn toward the L (left) position and if the left side is
louder, turn toward the R (right) position.
NOTE:
This control does not operate when the DIRECT button is in
the on position.