Filter
Top Products
34
English
3139 115 21993
IMPORTANT!
– Make sure the FM and AM antennas
are connected.
– The TUNING button on the front
panel is used to toggle between
frequency tuning and preset tuning.
When in preset tuning, “PRESET” appears
on the display panel and S / T
buttons on the front panel are used for
preset number selection. Otherwise,
pressing S / Twill change the radio
frequency.
Tuning to radio stations
1 Press TUNER on the remote (or adjust
SOURCE control on front panel) to select
“FM TUNER” or “AM TUNER.”
2 Press and hold S / T on the remote until
the frequency indication starts to change, then
release.
➜ The next radio station will tune automatically.
➜ lights up for FM stereo reception.
3 To tune a weak station, press S / T briefly
and repeatedly until an optimal reception is
found.
● If you use S / T on the front panel for
frequency tuning, make sure the system is in
frequency tuning mode. If not, press TUNING.
➜ PRESET will disappear from the display panel.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
AM bands.
Notes:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
DVD VIDEO D
STOPPLAY •PAUSE SEATING
SOURCE
PROG TUNINGCLOCK•TIMER
SURROUND
SEARCH
C CHANGER
SURR. LEFT SURR. RIGHT LEFT RIGHTCENTER SUBWOOFER
PLAY•PAUSE
AUTO INSTALL - PR
1 Connect the system to the power supply,
"AUTO INSTALL - PRESS PLAY" appears.
OR
In Eco Power standby/standby mode,
press and hold ÉÅ on the front panel until
"AUTO INSTALL - PRESS PLAY" appears.
2 Press ÉÅ on the front panel to start
installation.
➜ "INSTALL TUNER" appears.
➜ All previously stored radio stations will be
replaced.
➜ Once completed, the last tuned radio station
will play.
Tuner Operations
pg 001-044_MX39-37-Eng1 2/25/03, 9:59 AM34