Filter
Top Products
17
English
Helpful hints:
– During playback, the keys are automatically
released at the end of a tape and the set is
switched off (unless PAUSE
Å
has been
activated).
– During fast forwarding/rewinding, the keys will
not be released at the end of a tape. To stop fast
winding, press STOP•OPEN
70
.
General information on
recording
● For recording, use only tape of IEC type I
(normal tape).
● The recording level is set automatically, regardless
of the position of the Volume, DBB, DSC and so
forth.
● The tape is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for six to seven
seconds.
● To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
IMPORTANT!
– Recording is permissible if copyright
or other rights of third parties are not
infringed upon.
– Recording is possible only on tape
deck 1.
Ta pe Operation / Recording
IMPORTANT!
– Before playing a tape, check and
tighten slack tape with a pencil. Slack
tape may jam or burst in the mechanism.
– C-120 tape is extremely thin and is
easily deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature
and do not put them too close to a
magnetic field (for example, a
transformer, TV or speaker).
Loading tapes
1 Press POWER to on, then press TAPE to
select TAPE mode.
➜ Display: shows TAPE throughout tape
operation.
2 Press STOP•OPEN 70 to open the tape
deck door.
3 Load the tape with the open side downward and
full spool to the left.
4 Close the tape deck door.
Playing tapes
To playback a selected tape
● Press PLAY £on tape deck 1 or 2.
➜ The tape will stop at the end of playback..
Continuous playback of two tapes
1 Load the tapes in tape deck 1 and 2.
2 Press PLAY £ on tape deck 2.
3 On tape deck 1, press PAUSEÅ and then,
PLAY £.
➜ Playback will begin from tape deck 2 and
continue with tape deck 1. It will stop at the end
of tape deck 1.
4 To pause playback, press PAUSEÅ. To resume
playback, press PAUSEÅ again.
5 By pressing REWà / F. FWD á , fast
winding of the tape is possible in both directions.
To stop fast winding, press STOP•OPEN 70.
6 To stop the tape, press STOP•OPEN 70.