Filter
Top Products
12
English
Installation
Setting the clock
The time is displayed using the 12-hour clock.
1 Check the system is switched to standby mode.
(see Basic Functions, Switch on/to standby)
➜ AM 12: 00 flashes by default if the clock is
not set.
2 On the system, press and hold PROGRAM for
more than 2 seconds.
➜ The hour digit starts flashing.
3 Hold down or press 4 or ¢ repeatedly to
set the hour. Release 4 or ¢ when you
have reached the correct setting.
4 Press PROGRAM to confirm the setting.
➜ The minute digit starts flashing.
5 Repeat step 3 to set the minute.
6 Press PROGRAM to confirm the setting.
➜ The clock shows the set time.
Helpful hints:
–You may lose your clock setting when the power
cord is disconnected or power failure occurs.
Inserting batteries into the
remote control
Insert two batteries type R03 or AAA into the
remote control with the correct polarity as
indicated by the "+" and "-" symbols inside
the battery compartment.
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly.
1
2
3