Filter
Top Products
30
English
Changing tuning grid
In some countries, the frequency step between
adjacent channels in the MW band is 9 kHz (10
kHz in some areas). The preset frequency step in
the factory is 9 kHz.
1 Plug the AC power cord.
2 Press TUNER to select MW mode.
3 Press and hold 38 button for more than 5
seconds on the panel.
Note:
– All preset stations will be lost and need to be
reprogrammed.
Tuner Operations
Manual preset programming
1 Press TUNER key repeatedly to select the
desired tuner band: FM or MW.
2 Press and hold 1 / ¡ on the system or on
the remote control to search a radio frequency.
3 Press PROGRAM.
➜ “PROG“ and “00 00.00” will display.
4 Press O / P or numeric keys (0-9) to
select the desired preset number.
5 After selecting an address number, press
PROGRAM again to store the radio station.
● Repeat steps 3-5 to store other preset radio
stations.
Note:
– If you attempt to store more than 40 preset
radio stations, “FULL” will be displayed.
- The system exits presetting mode if no button
is pressed within 20 seconds.
Selecting a preset radio station
● In tuner mode, press O / P or use the
numeric keys (0-9) to select the desired
preset number.
➜ The preset number and radio frequency
appear on the display panel.
Deleting a preset radio station
1 In tuner mode, press O or P keys to select the
preset radio station to be erased.
2 Press and hold 7 on the system until
“DELETED” appears on the display panel.
➜ The radio station continues to play but has
been deleted from the preset list.
➜ The rest of the preset radio stations remain
unchanged.
● Repeat steps 1-2 to erase other preset radio
stations.
FWD185 final IFU ( v1.1) 1/1/32, 3:24 AM30