Filter
Top Products
29
English
Tuner Operations
IMPORTANT!
– Make sure FM and MW antennas are
connected.
Tuning to radio stations
1 Press SOURCE key on the front panel
repeatedly until “FM XX” or “MW XX” appears
on the display panel ( or press TUNER key on
the remote control).
2 Press and hold 1 / ¡ on the system or on
the remote control until “SERACH->”appeared,
then release.
➜ The first radio station with sufficient signal
strength will appear on the display.
3 To tune to a weak station, press 1 / ¡ on
the system or on the remote control to search
until a radio station with sufficient signal strength
is found.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
MW bands. There are three different ways to
program the radio stations:
- Using auto install (for first time setup only)
- Automatic preset programming
- Manual preset programming
Note:
- If no stereo signal is detected during tuner
installation, “ NO SIGNAL PLEASE CHECK
ANT” will appear on the VFD.
Using auto install
When you plug in the unit for the very first time,
you will be prompted to install the radio stations.
With this feature, you can install all the available
tuner station automatically with one touch of
button.
When “ AUTO INSTALL PRESS PLAY”
appears,
● Press 38 on the system,
➜ The system starts searching from the FM
band followed by the MW band.
➜ All the available radio stations with strong
signal will be strored automatically.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the first preset radio station will be played.
Automatic preset programming
You can start automatic presetting from a
selected preset number.
1 Press TUNER key to select TUNER mode.
➜ The current radio frequency will appear on
the display.
To begin automatic preset from a desired
preset number
● Press O / P or numeric keys (0-9) to
select the desired preset number.
2 Press and hold PROG on the remote control
(or press PROGRAM on the system) until
“>>> AUTO ” appears on the display.
➜ The system will start to search all radio
stations on the FM band, then MW band.
➜ All radio stations with strong signal strength
will be stored automatically.
➜ The system will stop searching when all
available radio stations are stored or when the
memory of 40 preset radio stations is full.
➜ If no stereo signal is detected during tuner
installation, “ NO SIGNAL PLEASE CHECK
ANT” will appear on the VFD.
To stop storing the automatic preset
● Press 7 to stop storing the automatic preset.
FWD185 final IFU ( v1.1) 1/1/32, 3:24 AM29