Filter
Top Products
14 C1641M-A (3/05)
Mounting the FR8301 Receiver Using the Wall Clip
NOTE:
Before mounting the FR8301 receiver to a wall, ensure that there is adequate
space at both ends for viewing the front-panel LEDs and for making the various rear-
panel cable connections.
To attach the FR8301 receiver to a wall using the supplied wall clip, refer to Figure 7 and do the
following:
1. Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall
using two screws (not provided).
2. Slide the module into the clip until the two holes on the bottom of the module align with
the two holes on the lower flange of the clip.
3. Attach the module to the clip using the two Phillips pan head screws provided for the clip.
Figure 7.
Mounting the FR8301 Receiver to a Wall Using the Wall Clip
FR8301
RECEIVER
WALL CLIP
LOWER
FLANGE
SCREW, PHILLIPS
PAN HEAD WITH
LOCK WASHER (2)
HORIZONTAL
MOUNTING HOLE (2)
UPPER
FLANGE
VERTICAL
MOUNTING HOLE (2)