C1641M-A (3/05) 13
MOUNTING THE FR8301 RECEIVER
The following sections provide information about mounting the FR8301 receiver into a rack or
onto a wall.
Mounting the FR8301 Receiver into a Rack
The FR8301 receiver can be installed into an RK5000 Series rack mount chassis, which can be
mounted into an industry-standard 19-inch (48.26 cm) equipment rack. The RK5000 Series rack
mount chassis includes the following models:
•
RK5000PS-3U and RK5000-3U:
Designed to accommodate fiber optic modules as
follows:
– The RK5000PS-3U rack mount chassis provides 12 module slots and a power
supply.
– The RK5000-3U rack mount chassis provides 14 module slots (a power supply is
not included). Power to the modules can be supplied using the optional external
power supply (EPS5000-120).
For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount
Chassis Installation manual.
•
RK5000PS-5U:
Designed to accommodate Endura
™
modules but can also accommodate
fiber optic modules with the use of the appropriate adapter kit. The RK5001-1UEXP
adapter kit is required for installation of the FR8301 receiver into the RK5000PS-5U
chassis.
For information about the RK5000PS-5U chassis, refer to the RK5000PS-5U Rack Mount
Chassis Installation manual.
Mounting the FR8301 Receiver to a Wall
The FR8301 receiver can be mounted to a wall in the following ways:
• Using the supplied wall clip for attachment of a single module to a wall. For installation
instructions, refer to the
Mounting the FR8301 Receiver Using the Wall Clip
section
below.
• Using the optional WM5001 wall mount kits, which are designed for mounting of single-
width fiber optic modules. The WM5001-3U base kit allows attachment of a single
module to the wall. The WM5001-3UEXP expansion kit allows attachment of an
additional module to the wall. It is recommended that a maximum of three expansion
kits be used with the base kit, allowing a maximum of four single-width modules to be
attached to the wall.
NOTE:
The WM5001 wall mount kits can be used with the WM5002 wall mount kits,
which are designed for mounting of double-width fiber optic modules. If mounting a mix
of single-width and double-width modules is desired, it is recommended that a
maximum of two single-width modules and one double-width module be mounted in
combination with one another.
For mounting instructions using the wall mount kits, refer to the WM5000 Series Wall
Mount Kit Installation manual.