Filter
Top Products
8
Front Panel
(1) MIC INPUT
Front panel Mic or line level input. Phantom power may be selected in software. May be used as a extra
input and routed through the system.
(2) DATA WHEEL
Rotate clockwise or counter clockwise to scroll through screens. Push to enter or confirm selection.
(3) LCD DISPLAY
This screen gives a graphical representation of unit configuration and parameter settings. The layout of the
screen and the information displayed will depend on the function being monitored or set.
(4) Parameter Select Buttons
SETUP: Configurations are selected here. Parameter selection for inputs, signal generator, stereo/
mono, routing matrix, and outputs.
EQ: parameter selection of input or output equalizers
DYNAMICS: parameter selection of input or output compressor/limiters
XOVER: parameters of the bandpass modules for each output or configured crossover
DELAY: delay time and polarity for each input or output
TOOLS: saving and loading of presets as well as default configuration
(5) Input/Output Monitoring:
LEDs indicate active or muted channel conditions. Mute switches are provided to manually mute inputs
or outputs. Signal LEDs are Green for normal signal level, Yellow at +18 dBu output and Red at +20 dBu,
just before the onset of clipping.
(6) USB ports:
Connection of memory stick/jump drive for preset storage and system update. The slot supports USB 2.0
memory sticks whose current draw is 150 ma or less.
NOTE: Some USB memory sticks with proprietary software may not function correctly.
Make sure the memory stick is properly formated and there are no autorun programs
installed.
Input Section
1
2
3
4
55
6