Filter
Top Products
11
SETUP:
Selecting this button takes you to the preset configuration page.
The VSX™ is pre-programmed with fourteen configuration
templates representing the most frequently used crossover
possibilities. As you scroll through the configuration presets you
will see and can adjust the basic filter types (only symmetrical
choices may be made here). Center frequencies of those filters
and a graphic representation of the filters will be displayed. You
must enter “OK” to accept the selection. Selecting and pressing
Exit or pressing the Setup button will return you to the main
screen. Upon returning to the main screen you will see the
graphic representation of your selection.
OUTPUT 1-8:
Output levels may be adjusted on this page. Press “done” or
push the setup button to return to the main screen.
Inputs or outputs should be selected on the top of the screen.
While on the top of the screen push the data wheel and an arrow
appears. Rotate the wheel to select which input or output you
wish to adjust.
PARAMETRIC EQs on inputs:
Inputs A thru D display a graphical representation of the six
parametric EQs that are available on each input.
BW: Bandwidth (in oct.)
F: Frequency being adjusted.
LVL: Level control. After selecting a frequency, rotating the data wheel allows boosting or cutting
the amplitude of the selected frequency +/- 15 dB in .5 dB increments.
Tip: Pressing the EQ button is a short cut to return to the top of the screen.
Setup/Configuration Screen
EQ Screen