Filter
Top Products
14
Inputs A B C & D or outputs 1-8 should be selected on the top of
the screen. While on the top of the screen push the data wheel
and an arrow appears. Rotate the wheel to select which input
or output you wish to adjust. Push the data wheel to accept.
Normally the output delays are used to align the phase response
of the drivers in a system while the input delays are useful for
adding delay to the entire system(s).
IN/OUT:
Toggles to engage or bypass the delay
NORM/REVERSE:
Toggles to invert the polarity from the present state. It may become necessary to flip the polarity many
times while adjusting the delay time or adjusting the cut-off rate of the filters. It is conveniently located on
this page for that purpose.
DELAY:
Adds delay to the selected input or output. The delay is displayed in milliseconds, feet and meters and
automatically calculates each as the data wheel is rotated. The range of each delay is 340 ms, 379.09
feet and 115.59 meters. The input delay amount will be added to the output delay amount for a possible
680 ms, 758.18 feet and 231.18 meters should a very long delay be necessary. One example would be for
use with delay towers.
Delay Screen