Filter
Top Products
14
MMoonnoo BBii--AAmmpp OOppeerraattiioonn
(sub woofer & mid/high enclosure)
1. Set
AAMMPP MMOODDEE
switch to
SSTTEERREEOO
.
2. Set the channel A AMP FUNCTION switch to
HHIIGGHH PPAASSSS
.
3. Turn on the channel A
LLOOWW CCUUTT
.
4. Set channel A
LLOOWW CCUUTT
frequency adjustment knob to match the low frequency cut-off or the -3 dB down point
of the sub woofer. (If you don’t know this specification‚ set it for 40 Hz.)
5. Set the channel A
CCRROOSSSSOOVVEERR
frequency adjustment knob to the desired crossover frequency (usually
100–150 Hz).
6. Set the channel B
AAMMPP FFUUNNCCTTIIOONN
switch to FULL RANGE.
7. Plug a short shielded cable into the high pass/full range output of channel A .
8. Connect the other end of the same cable to the channel B input .
9. Connect the Mono program signal to the channel A input .
10. Connect the sub woofer(s) (in parallel) to the channel A output .
11. Connect the mid/high enclosure(s) (in parallel) to the channel B output .
1
9
2
4
5
6
7
8
9
10
11
3
2 1 6
10 11
5 4 87
3