Filter
Top Products
Operating Instructions
TU-HDT206A
9
4.2 HD STB Start Up
Display Type
The first on-screen display of the installation
process will show Display Type selection.
Please change to the type of display the HD
digital receiver is connected to. The choice is
either LCD, PDP (Flat panel displays) or CRT
(eg Standard television).
Select using the cursor buttons on the
remote control keypad.
Note: Not all video formats are available in all
modes. The following table describes the
available formats in each mode.
CRT selection does not allow 720p video format.
Table 1: Output format table
Region Selection
The first time the digital receiver is installed, or after default settings are restored
(section 6.5 page18), please select the state or territory that you live in. This will
enable the digital receiver to display the correct local time.
Automatic Off Timer
This function requires a time to be set for the automatic shutdown of the digital
receiver. The receiver will automatic go into standby to save power. The time is
measured from the last received command sent to the receiver. The default setting is
6 hours.
After selecting the settings for Display Type, Region Selection and Automatic Off
Timer, press OK to confirm the selection. The digital receiver will automatically step
to the channel tuning process.
4.3 Automatic Channel Tuning
The first time the digital receiver is installed, or after default settings are restored, the
digital receiver will automatically scan for available digital services. This will take
around five minutes or so.
HD (YPbPr & RGB) HD (HDMI) SD (VIDEO, S-VIDEO)
LCD/Plasma
CRT LCD/Plasma
CRT LCD/Plasma
CRT
576i X X
576p X X X
1080i X X X
720p X X