Filter
Top Products
Operating Instructions
TU-HDT206A
7
4 Installation of the Digital Receiver
4.1 Connection of the Digital Receiver
The following illustrations show some examples for connecting this HD digital
receiver. Select the connection that is best suited for your needs. Many other
connections may be possible when optional devices such as RF cable splitters are
included in your system. These devices may cause signal degradation and, if too
many are used, poor quality picture and sound may result.
Terrestrial Antenna Cable Connection (A)
Connect the RF antenna cable to the HD
digital receiver RF IN connector. Also
connect the cable from RF OUT to the TV RF
IN connector on the rear of your television.
This connection allows your TV set to receive
normal analogue programs. (Refer to A)
Video Connections
The HD digital receiver has several types of video connections. Please select from
HDMI, YPbPr and RGB for high definition video, and VIDEO and S-VIDEO for
standard definition video. The HDMI, YPbPr and RGB sockets detect when a plug is
inserted and the digital receiver configures the video output to suit the connection
type made to the display.
YPbPr Connection (B)
Connect the YPbPr component video output
socket on your digital receiver to your display
device’s YPbPr component video input. Be
sure to match the colours on the RCA
sockets with the coloured plugs. (Refer to B)
At the start of the initial installation, the video
format is set as HD Format 576p. The video
format can be changed to other HD formats after
the installation is finished by “V Format” on the
remote control.
HDMI Connection (C)
Connect the HDMI output socket on your
digital receiver to your display device’s HDMI
input. The HDMI connection also includes
audio signals set at a fixed level. (Refer to C)
The HD digital receiver can also be
connected to a DVI input on a display.
Please check that DVI input can display the
digital receiver HD video formats. A HDMI to DVI
cable (not supplied) is required for this. Also the audio needs to be connected by the
RCA connector (red/white) cable. Note: If HDMI cable is removed when the digital
receiver is switched on, the OSD will NOT change to any other video output terminal.
The receiver must be switched off when the HDMI cable is removed.
(C)
HDMI Connection
(A) Aerial Connection
(B) YPbPr Connection