Filter
Top Products
Operating Instructions
TU-HDT206A
18
Manual Channel Search
In the “Manual Channel Search” window you can
set the specific channel to search. Press the left
or right button then OK to select the broadcast
RF channel you wish to search.
Note: The RF channel is not the same number
as the station identification.
Region Select
Using cursor buttons select the region you
live in. This setting will allow the digital receiver
to display the current time on the information
banner and on the control panel when the
receiver is in the stand-by mode.
Restore Default Setting
If you need to reset all the digital receiver
settings to the factory shipping settings, this
feature will do so. Once restore default settings
has been done, the installation procedure of the
STB will need to be done again. Please be very
careful before you confirm this action.
Receiver Software “System Update”
This digital receiver software can be updated to
the latest version software by “over air
download” (OAD).
To Update Automatically
Set “Allow Software Updates” to “Yes”.
If there is a new software version being
broadcast, the digital receiver will download this
automatically. The automatic updating sequence
happens when the digital receiver is switched to
standby and at approximately 3:30am nightly. The automatic updating sequence
takes several minutes to find and upgrade to new software and then switch back to
standby. The digital receiver will NOT perform the automatic update sequence if it is
switched on. Changing the setting to” No” stops the digital receiver from receiving
any software updates automatically.