Filter
Top Products
RQT9471
22
Setting distances
You can make this setting when using the surround speakers.
This setting is not displayed under different conditions.
By setting the distance from front/surround speakers to the listening-viewing position, the
sound delay time is automatically calculated and adjusted so that sound reaches the listener
at the same time.
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (
➜
page 21)
2. Press [
w
][
q
] to select “DISTANCE ” and press [OK].
3. Press [
w
][
q
] to select a speaker to set and press [OK].
FRONT : Front speakers
SURR : Surround speakers
4. Press [
e
][
r
] to select the distance and press [OK].
Adjustment range: 1.0 to 10.0 meter (3.0 to 30.0 ft (feet))
Factory setting : Front 3.0 meter (10.0 ft (feet))
Surround 1.5 meter (5.0 ft (feet))
5. Press [
RETURN] several times to select “EXIT ” and press
[OK] to fi nish the setting.
Note
Radio waves from this system reach the maximum range of 15 m (49 feet) within the same
room.
Setting 7.1-channel virtual surround
When playing back 7.1-channel LPCM signals, you can enjoy wider sound fi eld effects as if
another speaker is added. Factory setting is “AUTO ”.
When you do not want to use 7.1-channel virtual surround effect, select “OFF ” in this setting.
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (
➜
page 21)
2. Press [
w
][
q
] to select “7.1CH VS ” and press [OK].
3. Press [
e
][
r
] to select “OFF ” and press [OK].
AUTO : The setting is switched between ON and OFF depending on the input
signals.
Only when 7.1-channel LPCM signals are input, 7.1-channel virtual surround
is ON (When other signals are input, this setting is OFF.).
OFF : 7.1-channel virtual surround is always OFF.
Factory setting : AUTO
4. Press [
RETURN] several times to select “EXIT ” and press
[OK] to fi nish the setting.
Reducing standby power consumption
(In standby condition (HDMI off mode))
Standby through function (
➜
pages 9, 28) does not work in this mode if you have connected
through the HDMI terminal.
VIERA Link “HDAVI Control” (
➜
page 18) will not function when this system is off.
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (
➜
page 21)
2. Press [
w
][
q
] to select “HDMI ” and press [OK].
3. Press [
w
][
q
] to select “STNBY ” and press [OK].
4. Press [
e
][
r
] to select “OFF ” and press [OK].
OFF : Standby power consumption reduced
(approx. 0.2 W)
ON : “Standby through” is activated when this system is turned off. (Normal power
consumption)
Factory setting: ON
5. Press [
RETURN] several times to select “EXIT ” and press
[OK] to fi nish the setting.
Functions and settings
To return to the previous
display/To cancel during setting
operation: Press [
RETURN].
Play
Functions and settings
5%<622436;'PKPFF5%<622436;'PKPFF ඦ೨ඦ೨