Filter
Top Products
RQT9471
15
Setting front speakers only
Make this setting after the speaker setting on page 13 is complete.
Preparations
• Make sure that all equipment has been turned off.
(When the VIERA Link “HDAVI Control” compatible Panasonic TV (VIERA) and Blu-ray Disc player/DVD recorder (DIGA) are
connected, do not turn on TV (VIERA) and Blu-ray Disc player/DVD recorder (DIGA) until the setting is complete.)
• Turn the main unit on. (➜ page 13)
• Turn 2 speakers on. (➜ page 13)
• Prepare the remote control. (➜ page 7)
1. Set “2CH ” at the setting operation of “Changing the number of speakers to 2” below.
2. Turn the main unit off once.
3. Turn the main unit on again.
4. Press and hold [CH] on the remote control for about 3 seconds until “2 SPKR SET ” is
displayed on the main unit’s display.
• Always aim the remote control at the main unit for operation.
5. Press the remote control button corresponding to the speaker outputting the confi rmation
sound.
When the sound is
output from the front
speaker (left),
press [GAME].
When the sound is output
from the front speaker
(right), press [MUTE].
Front speaker
(left)
Front speaker
(right)
GAME MUTE
• Sound is output from either of the speakers.
• When you press the button corresponding to the confi rmation sound of speaker, another speaker outputs confi rmation sound.
Press the corresponding button in the same way and complete settings for all 2 speakers.
• When “COMPLETE ” disappears on the main unit’s display, the speaker setting is complete.
Note
• Check if the speakers are properly set after setting the speakers. (➜ page 14)
• If the speakers are set incorrectly in step 5, turn the main unit off then on again and perform steps 4 and 5.
• If [WIRELESS LINK] indicator does not change from red to green, see page 27 of “Troubleshooting guide”.
Changing the number of speakers to 2
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (➜ page 21)
2. Press [
w
][
q
] to select “SPEAKERS ” and press [OK].
3. Press [
e
][
r
] to select “2CH ” and press [OK].
2CH : When only front speakers are installed
4CH : When surround speakers are additionally installed (factory setting)
• When changing the number of speakers to 4, select “4CH ” and press [OK].
4. Press [
e
][
r
] to select “YES ” and press [OK].
• To cancel, select “NO ”.
5. Press [
RETURN] several times to select “EXIT ” and press [OK]
to fi nish the setting.
Note
When you select “EXIT ” and press [OK], the setting mode fi nishes in step 2.
Speaker setting
Connection
To return to the previous
display/To cancel during
setting operation: Press
[
RETURN].
5%<622436;'PKPFF5%<622436;'PKPFF ඦ೨ඦ೨