Filter
Top Products
RQT9471
14
When the speakers are detected, the Wireless Link display lights up on the main unit’s
display.
(Blinks during detecting operation.)
While the wireless speakers operate normally, the Wireless Link display lights, but when radio
waves are interrupted (When speakers are in standby condition, etc.), it blinks.
Display
W
Wireless Link
display
Checking the speaker setting
1. Turn the main unit on.
2. Press [TEST] on the remote
control to output the test signal.
3. Make sure that the display of main unit matches speaker locations.
The test signal is output from one speaker at a time for about 2 seconds in the order shown below.
“TEST L ”
→
“TEST R ”
→
“TEST RS ”
✽
→
“TEST LS ”
✽
Confi rm the correct setting locations in the following chart.
Display Speaker outputting the test signal
TEST L Front left
TEST R Front right
TEST RS
✽
Surround right (right back)
TEST LS
✽
Surround left (left back)
Note
If the speakers are not properly set, do either of the following.
• Move the speakers according to the unit’s display.
• Perform steps 3 and 4 of “Setting the speakers” (➜ page 13). When using only front speakers, perform steps 4 and 5 of
“Setting front speakers only” (➜ page 15).
4. Press [TEST] on the remote control to stop the test signal.
If the speaker is repaired or replaced
Perform the above “Checking the speaker setting” to confi rm that the speaker properly operates.
Do the following operations if the sound is not produced normally.
1. Press and hold [INPUT SELECTOR] on the main unit about 3 seconds until “4CH SEARCH ” is displayed.
2. Perform steps 2 to 4 of “Setting the speakers” (
➜
page 13).
Speaker setting
• When you turn the main unit off with the speakers on, the speakers automatically enter standby (Wireless link standby). The
color of [WIRELESS LINK] indicator turns to red.
• To reduce more of the power consumption of speakers in standby, turn the speakers off. The speakers enter standby (In standby
condition).
<Power consumption of speakers in standby>
Wireless link standby: approx. 0.8 W (for 1 speaker)
In standby condition: approx. 0.1 W (for 1 speaker)
✽ This is not displayed
when using the front speakers only.
Speaker setting
Connection
Press
• To adjust the speaker volume, press [VOL +, –].
5%<622436;'PKPFF5%<622436;'PKPFF ඦ೨ඦ೨