Filter
Top Products
19
RQT9952
Clock and timers
Setting the clock
This is a 24-hour clock.
1 Press [CLOCK/TIMER] to select “CLOCK”.
2 Press [R,
T
] to set the time then press [OK].
To check the time
Press [CLOCK/TIMER].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set
time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select “OFF”.
SLEEP 30 → SLEEP 60 → SLEEP 90 → SLEEP120
OFF
To check the remaining time
Press [SLEEP].
Note:
• The play timer and sleep timer or the record timer and
sleep timer can be used together.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play and record timer
(Except for Bluetooth
®
source)
You can set the timer to come on at a certain time to:
• Wake you up (play timer).
• Record from the radio or the external equipment
(record timer).
Play timer and record timer cannot be used together.
Preparation
Set the clock.
1 Press [CLOCK/TIMER] to select “
#
PLAY” or
“
#
REC”.
2 Press [R,
T
] to set the start time.
3 Press [OK].
4 Do steps 2 and 3 again to set the end time.
5 Press [R,
T
] to select the source you want to play
or record and then press [OK].
To start the timer
1 Prepare the audio source.
Play timer Prepare the music source you
want to listen to (disc, USB, radio
or external equipment) and set
the volume.
Record timer Connect the USB device to
USB B
and tune to the radio
station or select the external
equipment.
2 Press and hold [
#
, –PLAY/REC] and then press
the button again to select the setting.
TIMER OFF Cancel the setting.
#PLAY ON Start the play timer. “#PLAY” is
shown.
#REC ON Start the record timer. “#REC” is
shown.
The system must be switched off for the timer to
operate.
To check the settings
Press [CLOCK/TIMER] to select “
#
PLAY” or “
#
REC”.
In standby mode, press [CLOCK/TIMER] two times.
Note:
• The play timer starts at a low volume and increases
gradually to the preset level.
• The record timer starts 30 seconds before the set time with
the volume muted.
• The timer comes on at the set time every day if the timer
is on.
• If you switch off the system and switch on again while a
timer is in operation, the timer will not stop at the end time.
External equipment
Preparation
• Disconnect the AC mains lead.
• Switch off all equipment and read the appropriate
operating instructions.
Using the auxiliary input
You can connect the TV and listen to the audio through
this system.
1 Connect the TV to this system.
(
Z
7, “Alternative connection to a TV”)
2 Press [RADIO/AUX] to select “AUX 1”.
Note:
• You can also connect other equipment (such as Blu-ray
Disc player, DVD recorder, VCR, etc.) to the AUX 1 terminal
of this system.
• Sound distortion can occur when you use an adaptor.
SC-VKX25GAGS_RQT9952-B_En.indd 19SC-VKX25GAGS_RQT9952-B_En.indd 19 8/18/2014 3:36:48 PM8/18/2014 3:36:48 PM
printing rev.1
Confidential
Until:
29 Aug 2014