Filter
Top Products
Operations
RQT9670
25
∫ Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on the
main unit and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at this system’s remote
control sensor.
2 Press and hold [MUTE] and [ ] on the remote
control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the code of
this system is changed.
≥ The setting is maintained until it is changed again.
≥ If this system does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
steps above, but replace
[] with [TV].
∫ To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, for example, It is possible to reduce the dialog
enhancing effect as follows:
Press and hold [TV] on the remote control and followed by
[s VOL] on the main unit for more than 2 sec.
≥ All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥ Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you every time
this system turns on, for example, it is possible to turn off
this function as follows:
Press and hold [MUTE] on the remote control and
followed by [VOL r] on the main unit for more than 2 sec.
≥ All the indicators will blink once when the volume limitation
is turned off.
The settings of the clear-mode dialog effect and the volume
limitation remain intact even if you switch this system to
standby mode. To turn these 2 functions back on, this system
must be set back to the factory preset. (> 26)
Others
The following settings are unnecessary under
general usage conditions of the system.
SC-HTB351_RQT9670_mst.book Page 25 Tuesday, March 6, 2012 7:22 PM