Panasonic SCHTB350 Speaker User Manual


 
Getting started
RQT9670
17
Connect the speaker cables.
Insert the wire fully, taking care not to insert beyond the wire insulation.
Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with
the speaker cable with a white connector on the observers’ left.
To prevent the speakers from falling, it is recommended, as an additional
protection measure, to attach the speakers to the wall or table with a fall
prevention cord (hereafter “cord”).
Consultation with a qualified installation specialist concerning the appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support is recommended (>11, 13). Improper attachment may result in damage to
the wall and speakers, and personal injury.
Use a cord that is capable of supporting over 10 kg (22.05 lbs) (with a diameter of about 1.5 mm (
1
/16q)).
Keep the screws out of reach of children to prevent swallowing.
Make sure that the slack of the cord is minimal.
Additional speaker fall prevention measures
When attaching the speakers to a wall
A Cord
§
B Screw eye C Wall D Wall-mounted speakers
§ If the cord cannot be threaded through the holes, try bending the cord in 2 locations, about
10 mm (
13
/32q) apart from the tip, at an angle of 45
o
(as
illustrated above).
Insert the
wire fully.
r: White
s: Blue line
Press into the groove.
Push
Back of the base
Horizontal placement
Vertical placement
SC-HTB351_RQT9670_mst.book Page 17 Tuesday, March 6, 2012 7:22 PM