Getting started
9
VQT4D53
≥ Use a screwdriver (i) for assembling the speakers.
≥ Do not hold the speakers in one hand to avoid injury by dropping the speakers when carrying.
∫ When carrying the active subwoofer
≥ Place the active subwoofer in a horizontal position with the top panel faced upward.
≥ Placing the active subwoofer and the speakers too close to walls and corners can result in excessive bass. Cover walls and
windows with thick curtains.
≥ If irregular coloring occurs on your TV, turn the TV off for about 30 minutes. If it persists, move the speakers further away from the
TV.
≥ Keep magnetized items away. Magnetized cards, watches, etc., can be damaged if placed too close to the system.
Caution
≥ The active subwoofer and supplied speakers are to be used only as indicated in these instructions. Failure to do
so may lead to damage to the amplifier and/or the speakers, and may result in the risk of fire. Consult a qualified
service person if damage has occurred or if you experience a sudden change in performance.
≥ Do not attempt to attach these speakers to a wall using methods other than those described in this manual.
Speaker system
∫ When attaching the speakers to a wall
The wall or pillar to which the speakers are to be attached should be capable of supporting 33 kg (72.8 lbs) per screw.
Consultation with a qualified building contractor is recommended when attaching the speakers to a wall. Improper attachment may
result in damage to the wall and speakers, and cause personal injury.
∫ When placing the speakers in front of the TV
The speakers may block or interfere with the TV’s various sensors (C.A.T.S. (Contrast Automatic Tracking System) sensor, remote
control sensor, etc.) and the 3D Eyewear transmitters on a 3D compatible TV.
≥ If the stands are being used
Move the speakers farther away from the TV. If the TV still does not function properly, try removing the stands.
≥ If the stands are not used
Move the speakers farther away from the TV. If the TV still does not function properly, try placing them beside the TV (> 8).
Active subwoofer
The remote control signal sensor is located on the active subwoofer.
≥ Use the remote control within the correct operation range.
B Do not hold the active subwoofer from this opening.
The parts inside (speaker unit) may be damaged.
C Always hold the bottom of the active subwoofer when
moving it.
A
A Remote control signal sensor
≥ Remote control operation range
Distance: Within approx. 7 m (23 ft.)
directly in front
Angle: Approx. 30
o
left and right
B
C
SC-HTB20P_VQT4D53_eng.book 9 ページ 2012年1月16日 月曜日 午後8時3分