Filter
Top Products
Operations
23
VQT4D53
As a factory preset, Dolby Virtual Speaker and the
3D surround effects will be applied to Multi-channel
audio sources, such as those from a Blu-ray Disc
player or DVD player, etc.
By changing the audio output setting, it is possible
to apply the Dolby Virtual Speaker and 3D surround
effects to 2ch audio sources, such as the audio
from the TV.
Press and hold [MUTE] for more
than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
While the indicator is blinking,
press [MUTE] again to change
the setting.
≥ The setting changes each time [MUTE] is pressed.
§1 Depending on the audio source, Dolby Virtual Speaker and
3D surround effect settings are automatically adjusted.
§2 This indicator will also light when the audio source is Multi-
channel audio.
When using the optical digital audio cable, Dolby Virtual
Speaker and the 3D surround effect will be automatically
canceled if the audio signal’s sampling frequency is greater
than 48 kHz.
Audio output modes
To change the audio output
mode
Audio output mode
Dolby Virtual Speaker
and 3D surround
effect
Multi-channel mode
The effects are
applied to all audio
sources.
Auto mode (Direct mode)
§1
(Factory preset)
The effects are
applied to Multi-
channel audio
sources.
The effects are not
applied to 2 channel
audio sources.
2ch mode
The effects are not
applied to any audio
source.
2
SC-HTB20P_VQT4D53_eng.book 23 ページ ２０１２年１月１６日 月曜日 午後８時３分