Filter
Top Products
Getting started
11
VQT4D53
Connect the speaker cables.
≥ To make sure that the speaker cable is connected to the correct speaker, match the color of the speaker connector with the
color of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
≥ Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw (not supplied) into the wall.
≥ Use the measurements indicated below to identify the screwing positions on the wall.
≥ Leave at least 20 mm (
25
/32q) of space above and on each side of the speaker to allow enough space for fitting the speaker.
≥ The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg
(72.8 lbs).
≥ Keep the screws out of reach of children to prevent swallowing.
Fit the speaker securely onto the screw(s) with the hole(s).
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the
groove.
Push
A At least 30 mm (1
3
/16q)
B ‰4.0 mm (
5
/32q)
C ‰7.0 mm to ‰9.4 mm (
9
/32q to
3
/8q)
D Wall or pillar
E 5.5 mm to 6.5 mm (
7
/32q to
1
/4q)
Front view (semi-transparent image)
F 190.5 mm (7
1
/2q) G 187 mm (7
23
/64q) H 177 mm (6
31
/32q) I 200.5 mm (7
57
/64q)
J 12.5 mm (
1
/2q) K Wall mounting hole
DO DO NOT
≥ Move the speaker so
that the screw is in
this position.
≥ In this position, the
speaker will likely fall
if moved to the left or
right.
SC-HTB20P_VQT4D53_eng.book 11 ページ ２０１２年１月１６日 月曜日 午後８時３分