Filter
Top Products
5
RQT7921
Simple setup
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥Make sure you have all the indicated components before starting assembly, setup, and connection.
≥There is no difference between the right and left speakers and pipes.
1 Attach pipes B to the bases.
A Insert pipe B.
B Secure pipe B to the base.
Ensure the screws are securely fastened.
2 Assemble the pipes.
A Thread the speaker cable from Pipe A through Pipe B
and the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the pipe, and then
pull the rest of the cable through the base.
B Join Pipe A to Pipe B.
C Secure the pipes.
Ensure the screw is securely fastened.
3 Attach pipes A to the speakers.
Slot the screw head in between the 2 stoppers of the speaker
groove.
Align the screw head with the speaker groove.
Ensure the pipe is fastened on straight by gradually tightening the right
and left screws alternately until fully tightened.
To prevent short-circuit, do not cover the connection terminals
with the pipe.
4 Connect the speaker cables.
5 Secure the speaker cable to the base.
[Note]
You can use the front speakers without assembling with the stands. In this case, attach the included
rubber pads to the base of the speakers. This prevents vibration from causing the speakers to move or
fall over. Use 4 pads per speaker.
STEP1
Front speaker assembly
The supplied stands are specially designed for
attachment to Panasonic SB-FS730 front speakers.
Use only as indicated in this setup.
2kFront
speakers
2kBases
2kPipe A
(with a cable)
2kPipe B
4kPipes 4kWasher
screws
2kSmall
screws
4kBracket
screws
2kBrackets 8k
Rubber
pads
Match these holes when
you insert the pipe.
Base
Pipe B
Phillips-head
screwdriver
Washer screws
Cable
Pipe B
Cable
Pipe A
Pipe B
Small screw
Pipe B
Pipe A
Bracket screws
Front speaker
Connection terminals
Bracket
Pipe A
Stoppers
Screw head
Rear of the speaker
Twist off the vinyl ends of
the speaker cables.
_: White
`: Blue
Push!
Bottom side of base
A Press the speaker
cable into the
base cover groove
as far as possible.
Cable
B Press the speaker
cable against the
base while
threading it
between the pegs.
RQT7921-P_ENG.book 5 ページ ２００５年２月４日 金曜日 午後４時５８分