Filter
Top Products
RQT8720
6
Simple Setup
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥Make sure you have all the indicated components before starting assembly, setup, and connection.
≥There is no difference between the right and left speakers and stands.
≥For optional wall mount, refer to page 8.
[Note]
≥The front and surround speakers are different.
– Check the label on the rear of speaker before attaching the stand (➜ page 9).
– The stand with shorter cable is for the front speaker.
1 Attach the stand to the base.
1 Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
2 Attach the stand to the base while gently pulling on the
end of the speaker cable.
2 Secure the stand to the base.
3 Attach the speaker to the stand.
1 Pull out the end of the speaker cable and position it
between the ridges.
2 Attach the speaker to the stand.
STEP1
Assembling the front and
surround speakers
The supplied stands are specially designed
for attachment to Panasonic SB-FS71 front
speakers or SB-FS72 surround speakers.
Use only as indicated in this setup.
2 Front speakers and
2 Surround speakers
(with cover plate)
4 Bases4 Stands
≥2kstands with short cable:
For front speakers
≥2kstands with long cable:
For surround speakers
16 Screws
Base
Cable
Stand
Base
Cable
Pull gently.
Screw
Tighten securely.
Slide the speaker
cable into the groove.
Stand
Base
Screws
Tighten securely.
Cable
Ridges
Stand
Speaker
Stand
Cover plate
Remove before attaching
the speaker and keep for
wall-mount use (➜ page 8).
Assembling the front and surround speakers
HT744En.book Page 6 Thursday, March 23, 2006 1:30 PM