Panasonic SC-BT230 Home Theater System User Manual


 
e.g., I'_'_[]
I 3
Pull open.
1 Standby/on switch (POWER (b/I) (_ 19)
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a small
amount of power.
2 Power indicator
The indicator lights when this unit is turned on.
3 Connect iPod/iPhone (=> 32)
4 Adjust the volume of the main unit
5 Open or close the disc tray (_ 22)
6 Disc tray
7 SD card slot(_, 22)
8 IrCi'_m,II'¢i"i_,l Connect Auto speaker setup microphone
9 10 11 12 13
9 Display (FL display)
"SRD" (SURROUND) lights when sound is output to the
surround speakers.
The display is turned off when the volume is adjusted to
"0". (=> 37)
10 Remote control signal sensor
Distance: Within approx. 7 m (23 ft.)
Angle: Approx. 20° up and down, 30 ° left and right
11 Select the source (_ 23)
12 Stop (_ 25)
13 Start play (_ 25)
If the front cover comes off
(_ Hold rear side of main unit by one hand and match up left
or right side protruding hook on the cover first with the
corresponding slot on the unit.
@ Push the hook firmly towards the unit until it clicks into
place. Then push the succeeding hooks one by one until
all have clicked into place.
_) Check that the cover now moves correctly.
If it does not, remove it and repeat the above procedure.
e.g., I'_"_ _1
9 10 11
1 AC IN terminal(_ 18)
2 Speaker terminals (_ 13)
3 Cooling fan
4 USB port for optional wireless adaptor (_ 17)
5 HDMI AV OUT terminal(_ 15)
6 FM radio antenna terminal (_ 16)
7 DIGITAL AUDIO IN terminals (_ 14, 15)
Terminal 1 is designated for connection with the TV.
Terminal 2 can be used with equipment other than the
STB.
8 Digital transmitter dock (_ 16)
9 LAN port (_ 17)
10 VIDEO OUT terminal (_ 14)
11 AUX terminal (_ 14)
Saving energy
This unit is designed to conserve its power consumption and save energy.
This unit will automatically turn to standby mode after 30 minutes if it is inactive.
VQT2M 13