Panasonic SC-BT230 Home Theater System User Manual


 
Before you perform the wireless network settings on this unit,
confirm the set up of your Wireless router (Access point) is
done correctly on your PC.
1 Select "Wired" or "Wireless" and press
[OK].
When you experience
problems with settings
Access Point Connection Setting
2 Follow the on-screen instructions and
make the settings with [&, T] and press
[OK].
For wireless LAN connection:
If you are using a Wireless router (Access point) that supports
WPS, you can easily perform the settings by selecting "WPS
(PUSH button method)".
Otherwise, perform the settings by selecting "Search for
access point" or "Manual setting" in "Other methods".
WPS (Wi-Fi Protected Setup) is a function that facilitates
settings relating to the connection and security of wireless
LAN devices. To see whether your Wireless router (Access
point) supports WPS, check the Wireless router operating
instructions.
A conflict with another
device occurred.
A time out error occurred.
An authentication error or a
time out error occurred.
A device error occurred.
Please wait a few moments,
and then try again.
Setting of the Wireless
router (Access point) for
MAC Address etc.
The signal may be weak.
Using the USB extension
cable included with the
Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
The SSID and the
encryption key of the
Wireless router (Access
point).
Please wait a few moments,
and then try again.
Connection of Wireless LAN
Adaptor
If there is no improvement in
symptom, contact our
Customer Service Center.
Network Easy Setting (Connection Check)
Yes
1. LAN cable connection or
Connection to access point :Fail
2. IP address setting :Fail
3. Connect on to gateway :Fail
Connection of I
the LAN
cabes (_ 17)
VQT2M 13