Filter
Top Products
• Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
• The wall or pillar on which the speakers are to be attached should be
capable of supporting over 10 k8 (22 Ibs) [_ 15 kg (33 Ibs)
for the front speakers] per screw. Consult a qualified building
contractor when attaching the speakers to a wall. Improper
attachment may result in damage to the wall and speakers.
• When mounting the front speakers to a wall, we recommend using
a string (not included) to prevent it from falling.
Front speaker -H_940_
255 ram
(10V_d')
Center speaker
19gram
(7_5/3/')
Surround speaker[HT940i
Preparation for front speakers
1 Remove the speaker cable from the stand.
2 Connect the cable (4 page 4).
HT940i
1 Pull down the longer part
of the cable to release
the cable from the groove
inside the stand, and
then pull the speaker sable out from the stand,
2 Feed the cable into the bottom of the
speaker and through the slot at the rear.
3 Connect the cable (4 page 5).
L'_ l _ Attach the cover plate to the front speaker.
Cover plate _ _-- Screw
@ Drive a screw (not included) into the wall.
CO _ ,, "_ -'i-©7.5 to 9.5 mm
4.0 mm ( Is_) - _ .3_ (W_L' to _I_")
Wall or pillar _J 5.0 to 7.O mm (3/,8"to _/S)
(_ Fit the speaker securely onto the screw(s) with the hole(s).
Front speaker l IIF_ Center speaker I II1_
200 mm
Surround speaker I
In this position, the
speaker wi}}likely
fatt if moved to the
left or right.
peaker
so that the screw
is in this position.
Reattaching the speaker cable to the stand
I Remove the eight screws _Screw
from the stand, and remove
the speaker net.
2 Position the cable.
Press the cable into
the groove,
Cable
3 Attach the speaker net with the screws.
I Remove the two screws from the stand, and remove the metal cover.
Plaatio cover
2 Pull the cable out about 40 cm (153/#') from the hole in the metal
cover, and insert the plastic cover.
Approx, 40 em (153/#')
insert the metal cover
so it does not disturb
the cable and close
tightly with the two screws.
• fitting speaker stands (notincluded)
(Except front speakers)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
• The stands must be able to support over 10 k8 (22 Ibs).
• The stands must be stable even if the speakers are in a high position.
e.g, Center speaker l
Metal screw holes
For attaching to speaker
stands
5 mm (31,d'),pitch 0.8 mm 1'/32") _11_
Plate thickness plus 7 mm .._._.. _[T&/,_]_
te 10 rnm (plus _/3/' to '3/3#) 60 mm (P/f')
Speaker stand (not included)