Filter
Top Products
5
Step 1
RQT7523
U
T
P
R
IN
DVR/VCR1
YP
B
P
R
YP
B
P
R
TV IN
DVD IN
COMPONENT VIDEO
FRONT B
CENTER
SURROUND
SPEAKERS (6
∼
8
Ω
) HAUT-PARLEURS
AC IN
∼
FRONT A
R L
BACK
R L
(DVD) IN
LF
R L
BI-WIREHF
Class 2 Wiring
Connecting speakers
Front speakers ( left right)
Place on the left and right of the TV at seated ear height so that there is
good coherency between the picture and sound.
Center speaker ( )
Place underneath or above the center of the TV. Aim the speaker at the
seating area.
Surround speakers ( left right)
Place on the side of or slightly behind the seating area, about one meter
(3 feet) higher than ear level.
Surround back speaker ( )
Place behind the seating area, about one meter (3 feet) higher than ear
level.
Subwoofer ( )
The subwoofer can be placed in any position as long as it is at a
reasonable distance from the TV.
Note that some experimentation with positioning can yield the
smoothest low frequency performance. Placement near a corner can
increase the apparent output level, but can result in unnatural bass.
Cable Speaker terminals
Twist
the wire.
FRONT Other terminals
Note If using 4-mm plugs
Do not short-circuit.
( )
( )
Peripheral equipment and cables sold separately unless otherwise indicated.
To connect equipment, refer to the appropriate operating instructions.
Front
right
Front
left
Surround
right
Surround
left
Surround
back
Speakers
Speaker
impedance:
Front A: 6-8 Ω
A and B:
6-8 Ω
Center: 6-8 Ω
Surround: 6-8 Ω
Center
Active
subwoofer
Monaural
connection
cable
Connect this cord after all other cables
and cords are connected.
Note
• The included AC power supply cord is for
use with this unit only. Do not use it with
other equipment.
• Do not use an AC power supply cord
from any other type of equipment with
this unit.
• If the unit is left unplugged for longer than
two weeks, all settings will revert to the
factory settings. Do the settings again if
this occurs.
Household AC outlet
(AC 120 V/60 Hz)
Speakers/
AC power supply cord
AC power
supply cord
(included)
Fully tighten the terminal,
then insert.