Filter
Top Products
24
RQT9223
Auto speaker setup using the setup microphone
Using the supplied setup microphone, you can measure such items as distance from the seating area, polarity and size
and make adjustments for connected speakers.
Keep quiet during the auto speaker setup. Conversational voice, air-conditioning noise and small sounds made
by winds may cause an error or produce an incorrect setting. Speakers output loud test signals during the auto
speaker setup. Make sure to keep little children out of the room.
Mute the TV volume before starting the auto speaker setup.
When the subwoofer is connected, make sure it is turned on. (There are subwoofer models that turn off automatically.)
Set the subwoofer volume to the normal listening level.
Select “YES ”
in “Making bi-wire setting” (➔ page 38) when you connect the unit to bi-wire speakers.
WIRELESS READY
SURROUND M.ROOM
INPUT SELECTOR
VOLUME
+
_
MULTI CH
PROCESSING
TrueHD
D
+
DTS-HD
MULTI CH
LPCM
B
I-AMP
SETUP MIC
AUX
TUNE
RETURN
AUTO SPEAKER SETUP
-
SETUP
OK
SURROUND
SPEAKERS A
SPEAKERS B
S VIDEO
VIDEO
L
- AUDIO - R
“ ”
“AUTO SPEAKER SETUP”
SPEAKERS A
POWER
POWER
TV/VIDEO
ENTER
SUB MENU
S
1
To turn the unit on
Press [
^
].
The standby indicator “
^
”
goes off when you turn the unit on.
• You can also turn this unit on by pressing [POWER
8
] on the unit.
2
Confirm “
A
” is displayed on the unit’s display.
• If “
A
” is not displayed, press [SPEAKERS A].
3
Connect the setup microphone (included).
Setup microphone
SETUP MIC
AUX
AUTO SPEAKER SETUP
SURROUND
SPEAKERS A
SPEAKERS B
S VIDEO
VIDEO
L - AUDIO - R
POWER
4
Place the setup microphone (included).
Place the setup microphone on a flat surface to
stabilize it.
Examples: A level bench sharing the height with
the seating area, a top section of a
sofa etc.
Set the microphone at seated ear height.
Use a tripod (for camera and other products) for
best results.
•
•
•
5
To start the setup
Press and hold [–AUTO, TEST] (on the remote control)
for 2 seconds.
The “AUTO SPEAKER SETUP” indicator flashes.
The unit cancels the auto speaker setup halfway through when you give a different
operational instruction before the setup finishes.
To cancel the setup halfway, press [–AUTO, TEST].
•
•
•
6
To finish the setup
When all auto settings are made, “COMPLETE ” appears and the “AUTO SPEAKER
SETUP” indicator lights on.
You can perform other operations after “COMPLETE ” is displayed. The unit keeps the
settings
even if you move straight on to another operation.
Press [–AUTO, TEST] (on the remote control).
Unplug the setup microphone when the setup is finished.
•
•
•
•
•
•
•
Tripod etc.
SA-BX500-PP (RQT9223-Y)_En.indd 24 6/27/2008 4:05:47 PM