Filter
Top Products
[DISPLAY OPTION] menu
ENGLISH - 93
Settings
[HDMI IN]
Switch the setting when the projector is connected to
an external device via an HDMI cable and the image
is not projected correctly.
1) Press
to select [HDMI IN].
2) Press the <ENTER> button.
z
The [HDMI IN] screen is displayed.
3) Press
to switch [HDMI SIGNAL
LEVEL].
z
The setting will change as follows each time
you press the button.
[0-1023] [64-940]
[0-1023]
Select when the DVI-D terminal
output of an external device (such
as a computer) is connected to the
<HDMI IN> terminal via a conversion
cable or similar cable.
Select also when the HDMI terminal
output of a computer or other device
is connected to the <HDMI IN>
terminal.
[64-940]
Select when the HDMI terminal of
an external device (such as a blu-
ray disc player) is connected to the
<HDMI IN> terminal.
Note
z
The optimal setting is different depending on the
output setting of the connected external equipment.
Refer to the instruction manual of the external
equipment regarding the output of the external
equipment.
z
The HDMI signal level is displayed per each 30 bits
of input.
[SDI IN]
(PT-DZ21KU and PT-DS20KU
only)
Set to match the signal to input to the <SDI IN
1>/<SDI IN 2> terminal.
1) Press
to select [SDI IN].
2) Press the <ENTER> button.
z
The [SDI IN] screen is displayed.
3) Press
to select an item.
■
To set [SDI LINK]
4) Select [SDI LINK] in Step 3).
5) Press
to switch [SDI LINK].
z
The setting will change as follows each time
you press the button.
[SINGLE LINK] [DUAL LINK]
[SINGLE
LINK]
Set SDI1 input and SDI2 input to
single link.
[DUAL LINK]
Set SDI1 input and SDI2 input to
dual link.
■
To set [SDI SIGNAL LEVEL]
Select the amplitude of the signal to input.
4) Select [SDI SIGNAL LEVEL] in Step 3).
5) Press
to switch [SDI SIGNAL
LEVEL].
z
The setting will change as follows each time
you press the button.
[64-940] [4-1019]
[64-940] Normally use this setting.
[4-1019]
Select when gray is displayed as
black.