Filter
Top Products
[NETWORK] menu
ENGLISH - 129
Settings
■
Error information page
When [Error (Detail)] or [Warning (Detail)] is displayed in the self-diagnosis display of the [Projector status]
screen, click it to display the error/warning details.
z
The projector may go into the standby status to protect the projector depending on the contents of the
error.
[OK]: Normal operation
[FAILED]: Occurrence of trouble
[WARNING]: Warning
z
Description of problem occurrence [FAILED]:
Parameter Description
[MAIN CPU BUS]
There is a problem with the microcomputer circuitry. Consult your
dealer.
[FAN]
There is a problem with the fan or the fan drive circuit. Consult your
dealer.
[INTAKE AIR TEMPERATURE]
The air intake temperature is too high. It may be used in an operating
environment where the temperature is high, such as near a heating
appliance.
[OPTICS MODULE TEMPERATURE]
The temperature inside the projector is high. It may be used in an
operating environment where the temperature is high, such as near
a heating appliance.
[AROUND LAMP TEMPERATURE]
The temperature around the lamp is high. The air exhaust port may
be blocked.
[LAMP1 REMAIN TIME]
The usage time of the lamp has exceeded the specied time, and it
is time to replace the lamp.
[LAMP2 REMAIN TIME]
[LAMP3 REMAIN TIME]
[LAMP4 REMAIN TIME]
[LAMP1 STATUS]
The lamp has failed to turn on. Wait a while until the luminous lamp
cools off, and then turn on the power.
[LAMP2 STATUS]
[LAMP3 STATUS]
[LAMP4 STATUS]
[APERTURE(CONTRAST-SHUTTER)]
There is a problem in the contrast shutter circuit for dynamic iris.
Consult your dealer.
[SHUTTER(MUTE-SHUTTER)] There is a problem with the shutter circuitry. Consult your dealer.
[INTAKE AIR TEMP.SENSOR]
There is a problem with the sensor used to detect intake air
temperature. Consult your dealer.
[OPTICS MODULE TEMP.SENSOR]
There is a problem with the sensor used to detect temperature inside
the projector. Consult your dealer.