Panasonic PT-DZ21KU Home Theater System User Manual


 
[PROJECTOR SETUP] menu
108 - ENGLISH
Settings
[RS-232C]
Set the communication conditions of the <SERIAL
IN>/<SERIAL OUT> terminal.
1) Press

to select [RS-232C].
2) Press the <ENTER> button.
z
The [RS-232C] screen is displayed.
3) Press

to select an item.
To set the communication
condition of the <SERIAL IN>
terminal
4) Select [(IN) BAUDRATE] in Step 3).
5) Press
󱚣󱚤
to switch [(IN) BAUDRATE].
z
The setting will change as follows each time
you press the button.
[9600] [19200] [38400]
6) Press

to select [(IN) PARITY].
7) Press
󱚣󱚤
to switch [(IN) PARITY].
z
The setting will change as follows each time
you press the button.
[NONE] [EVEN] [ODD]
To set the communication
condition of the <SERIAL OUT>
terminal
4) Select [(OUT) BAUDRATE] in Step 3).
5) Press
󱚣󱚤
to switch [(OUT)
BAUDRATE].
z
The setting will change as follows each time
you press the button.
[9600] [19200] [38400]
6) Press

to select [(OUT) PARITY].
7) Press
󱚣󱚤
to switch [(OUT) PARITY].
z
The setting will change as follows each time
you press the button.
[NONE] [EVEN] [ODD]
To set the response
4) Select [RESPONSE(ID ALL)] in Step 3).
5) Press
󱚣󱚤
to switch [RESPONSE(ID
ALL)].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON]
Returns the response when the ID
setting is ALL.
[OFF]
Does not return the response when the
ID setting is ALL.
6) Press

to select [GROUP].
7) Press
󱚣󱚤
to switch [GROUP].
z
The setting will change as follows each time
you press the button.
[A] [B] [Z]
[A] to [Z]
Controls multiple projectors
simultaneously by sending the ID of
RS-232C. Set the group from [A] to [Z].
The projector responds when the ID of
RS-232C matches the setting.
8) Press

to select [RESPONSE(ID
GROUP)].
9) Press
󱚣󱚤
to switch [RESPONSE(ID
GROUP)].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON]
Returns the response when the ID
setting is GROUP.
[OFF]
Does not return the response when the
ID setting is GROUP.
Note
z
Refer to “<SERIAL IN>/<SERIAL OUT> terminal”
(
page 160) for the <SERIAL IN>/<SERIAL OUT>
terminals and ID transmission in RS-232C.