Panasonic PT-DX800UL Home Theater System User Manual


 
Maintenance/Replacement
ENGLISH - 91
Maintenance
Lamp unit
The lamp unit is a consumable component. Check the usage duration in the [PROJECTOR SETUP] menu
[STATUS] (
page 64) and perform regular replacement.
It is recommended that you request a qualied technician to replace the lamp unit. Consult your dealer.
Consult your dealer to purchase a replacement lamp unit (ET-LAD60A: 1 pc, ET-LAD60AW: 2 pcs).
Attention
z
Do not replace the lamp unit when it is hot. (Wait at least one hour after use.)
The inside of the cover can become very hot, take care to avoid burn injuries.
Notes on the replacement of the lamp unit
z
Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object.
Please handle with care.
z
A Phillips screwdriver is necessary when replacing the lamp unit.
z
When replacing the lamp unit, be sure to hold it by the handle.
z
The lamp may burst. Replace the lamp unit carefully so that the broken pieces of the lamp glass will not
scatter. When the projector is mounted on the ceiling, do not make the replacement directly under the lamp
unit or put your face near it.
z
The lamp contains mercury. When disposing of used lamps, ask your nearest ward ofce or dealer about
proper disposal of the unit.
Attention
z
Use only specied lamp units.
z
The part numbers of accessories and separately sold components are subject to change without notice.
When to replace the lamp unit
The lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary
to replace it regularly. The estimated duration before replacement is 2 000 hours. However, this may be
shortened depending on individual lamp characteristics, usage conditions, and the installation environment.
Therefore, it is strongly recommended that a replacement lamp unit be kept. The unit can damage the
projector if it has not been replaced after 2 000 hours of usage. Thus, the lamp automatically turns off after
approximately ten minutes.
On screen Lamp indicator
Over 1 800 hours
The message is displayed for 30 seconds.
Pressing any button on the control panel
or remote control within 30 seconds will
clear the message.
Lights in red even during the standby
mode. (only the corresponding lamp
lights up)
Over 2 000 hours
The message remains displayed until you
press any button.
Note
z
2 000 hours of use is a rough guideline, but this is not a guarantee.
REPLACE LAMP