Filter
Top Products
[PICTURE] menu
ENGLISH - 47
Settings
[AI]
You can project the optimal image with contrast
by controlling the gradation in accordance with the
image.
1) Press ▲▼ to select [AI].
2) Press ◀▶ or the <ENTER> button.
z
The [AI] individual adjustment screen is
displayed.
3) Press ◀▶ to switch [AI].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON] AI correction is enabled.
[OFF] AI correction is disabled.
[SYSTEM SELECTOR]
The projector will automatically detect the input signal,
but you can set the system method manually when
an unstable signal is input. Set the system method
matching the input signal.
1) Press ▲▼ to select [SYSTEM
SELECTOR].
2) Press the <ENTER> button.
3) Press ▲▼ to select the system
method.
4) Press the <ENTER> button.
■ When entering signals to the
<VIDEO IN>/<S-VIDEO IN>
terminal
z
Select [AUTO], [NTSC], [NTSC4.43], [PAL],
[PAL-M], [PAL-N], [SECAM], or [PAL60].
Attention
z
Set it to [AUTO] normally.
z
Switch the setting to the signal method for the TV
used. The NTSC signal method is used in Japan.
Note
z
Setting [AUTO] will automatically select [NTSC],
[NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or
[PAL60].
■ When entering signals to the
<RGB 1 IN>/<RGB 2 IN> terminal
z
Only during 480i, 576i, or 576p signal input
Select [RGB] or [YC
B
C
R
].
z
Only during VGA60 or 480p signal input
Select [VGA60], [480p], or [480pRGB].
z
During movie signal input other than previously
listed
Select [RGB] or [YP
B
P
R
].
Note
z
Refer to
“
List of compatible signals
”
(
page 102) for
compatible signals.