Filter
Top Products
[PROJECTOR SETUP] menu
62 - ENGLISH
Settings
3) When the conrmation is displayed,
select [OK] or [CANCEL], and press
the <ENTER> button.
Note
z
The speed of the fan is raised and the operation
sound will become louder when this is set to [ON].
[COOLING CONDITION]
You can change the fan control depending on the
direction of projection.
Set [COOLING CONDITION] correctly in accordance
with the direction of projection referencing the
following gure. It may shorten the life of the lamp if
used in incorrect setting.
1) Press
▲▼
to select [COOLING
CONDITION].
2) Press the <ENTER> button.
z
The [COOLING CONDITION] screen is
displayed.
3) Press
▲▼
to select the cooling
condition.
[VERTICAL UP
SETTING]
[FLOOR SETTING] [CEILING SETTING]
[VERTICAL
DOWN SETTING]
Projection direction
4) Press the <ENTER> button.
5) When the conrmation is displayed,
select [OK] or [CANCEL], and press
the <ENTER> button.
[LAMP SELECT]
You can set the brightness using the two luminous
lamps built inside the projector to dual-lamp or single-
lamp brightness in accordance with the condition or
purpose of the usage. Setting [SINGLE] automatically
switches the lamp to be turned on based on the
duration of use.
1) Press
▲▼
to select [LAMP SELECT].
2) Press ◀▶ to switch [LAMP SELECT].
z
The setting will change as follows each time
you press the button.
[DUAL] [SINGLE]
[LAMP2] [LAMP1]
[DUAL] Two lamps will light.
[SINGLE]
One lamp will light. (The lamp
with shorter duration of use is
automatically selected.)
[LAMP1] Lamp unit 1 will light continuously.
[LAMP2] Lamp unit 2 will light continuously.
3) Press the <ENTER> button.
Note
z
In the [SINGLE], [LAMP1] or [LAMP2] mode,
one lamp remains off or the currently active lamp
exceeds 2 000 hours of cumulative operating time
(when [HIGH] is selected as the [LAMP
POWER]
setting), the other lamp will light. In the [DUAL]
mode, one lamp remains off or the currently active
lamp exceeds 2 000 hours of cumulative operating
time (when [HIGH] is selected as the [LAMP
POWER] setting), the other lamp alone will light.
However, if both lamps remain off or the 2 000
hours of cumulative operating time (when [HIGH] is
selected as the [LAMP POWER] setting).
z
The text colors of the items indicate the status.
Green
Current setting
Yellow
Current setting
(When there is a lamp that cannot turn on or
failed to turn on)
Red
Lamp that has failed to turn on
White
Any other status
z
If the projector is repeatedly used for short periods
of time, the lamps will need to be replaced more
frequently.