Filter
Top Products
11
RQT7534
10HBI
10HBI
10HBI
Radio operations
L FM frequency settings
You can change the FM step. The step is factory-set to 0.2 MHz, but
you can change it to receive broadcasts allocated 0.1 MHz steps.
1 Press [TUNER/BAND] to select “FM”.
2 Press and hold [SELECTOR] on the main unit.
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Note
Any FM/AM frequencies preset in channels will be changed by this
procedure. Preset them again.
Preset tuning
There are two methods of pre-setting stations.
Automatic presetting: All the stations the tuner can receive are
preset.
Manual presetting: You can select the stations to preset and the
order they are preset in.
Up to 15 stations can be set in each, the FM and AM bands.
Automatic presetting
Do the following once
For each, FM and AM.
Tune to the frequency where pre-setting is to begin.
Press and hold [ENTER] until the frequency changes.
¡ Main unit: Press and hold [MEMORY].
The tuner presets all the stations it can receive into the channels in
ascending order.
“SET OK” is displayed when the stations are set. The last
station to be set is then played.
L “ERROR” is displayed
Presetting was unsuccessful. Preset manually.
Manual presetting
1 Tune to the station (A see left: “Manual tuning”).
2 Press [ENTER].
3 While “PGM” is flashing
Press the numbered buttons to select a channel.
Alternatively, press [2 CH 1] then press [ENTER].
The station occupying a channel is erased if another station is
preset in that channel.
Selecting channels
1 Press [TUNER/BAND] to select “FM” or “AM”.
2 Press the numbered buttons or [4 CH 3] to select the
channel.
To select a 2-digit number
Example: To select channel 12, press [X10] A [1] A [2]
Control reference guide