Filter
Top Products
j Whenusing a subwoofer of 70W (2W), be
sure to connect the subwoofer to the violet
and violet/black leads of this unit. Do not
connect anything to the green and green/
black leads.
k Not used.
l Subwoofer(4W)×2
Notes
! With a 2 speaker system, donot connect any-
thing to the speaker leads that arenot con-
nected to speakers.
! Change the initial menu of this unit. Referto
SP-P/O MODE (rear output and preout set-
ting) on page 16.
The subwoofer output of this unit is monau-
ral.
Power amp (sold separately)
Perform these connections when using the op-
tional amplifier.
1
1
3
2
4
55
3
2
6
77
1 System remotecontrol
Connect to Blue/white cable.
2 Power amp (sold separately)
3 Connectwith RCA cables (sold separately)
4 ToFront output
5 Front speaker
6 ToRear output or subwoofer output
7 Rearspeaker or subwoofer
Installation
Important
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
— itmay interfere withoperation of the vehicle.
— itmay cause injury to apassenger as aresult
of asudden stop.
! The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of lessthan 60°.
60°
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are notblock-
ing the vents.
5cmcm
Leave ample
space
5 cm
5 cm
DIN front/rear mount
This unit can be properly installed using either
front-mount or rear-mount installation.
Use commercially available parts when instal-
ling.
DIN Front-mount
1 Insert the mounting sleeve into the dash-
board.
For installation inshallow spaces, use the sup-
plied mounting sleeve. If there is enough space,
use the mounting sleeve that came with theve-
hicle.
2 Secure the mounting sleeve by using a
screwdriver to bend the metaltabs (90°) into
place.
1
2
1 Dashboard
2 Mounting sleeve
# Make surethat the unit isinstalled securely in
place. Anunstable installation maycause skipping
or othermalfunctions.
DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracketand the side
of the unit match.
2 Tighten two screws on each side.
1
2
3
1 Screw
2 Mounting bracket
3 Dashboard or console
! Use eithertruss (5mm × 8mm) or flushsur-
face (5mm ×9mm) screws, dependingon
the bracketscrew holes.
Removing the unit
1 Remove the trim ring.
1 Trimring
2 Notched tab
! Releasing thefront panel allowseasier ac-
cess tothe trim ring.
! When reattachingthe trim ring,point the
side withthe notched tabdown.
2 Insert the supplied extraction keys into
both sides of the unit until they clickinto
place.
Installation
18
Section
Installation
En
03
<QRD3123-A/N>18