Filter
Top Products
! SUB.W,SUB.W CTRL andHPF SETTING are
not availablewhen REAR/REAR isselected in
SP-P/O MODE. Fordetails, refer to
SP-P/O MODE(rear output and preout set-
ting) onpage 16.
! SUB.W CTRLand HPF SETTINGare not avail-
able whenSUB.W is selectedin OFF. For de-
tails, referto SUB.W (subwoofer on/off
setting) onthis page.
FADER(fader adjustment)
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to adjustthe front/rear speaker bal-
ance.
BALANCE (balanceadjustment)
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to adjustthe left/right speaker bal-
ance.
EQ SETTING(equalizer recall)
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to selectthe equalizer.
POWERFUL—NATURAL—VOCAL—CUS-
TOM1—CUSTOM2—FLAT—SUPER BASS
The equalizerband and equalizer levelcan be
customized whenCUSTOM1 or CUSTOM2is
selected.
If selectingCUSTOM1 or CUSTOM2,complete
the proceduresoutlined below. If selecting
other options,press M.C. to returnto the pre-
vious display.
! CUSTOM1 canbe set separatelyfor each
source. However,USB, iPod andPAN-
DORA areall set to thesame setting auto-
matically.
! CUSTOM2 isa shared settingused in com-
mon forall sources.
3 Press M.C. todisplay the settingmode.
4 Press M.C. tocycle between thefollowing:
Equalizer band—Equalizerlevel
5 TurnM.C. to selectthe desired setting.
Equalizer band:80HZ—250HZ—800HZ—
2.5KHZ—8KHZ
Equalizer level:+6 to –6
LOUDNESS (loudness)
Loudness compensatesfor deficiencies inthe low-
frequency andhigh-frequency ranges at lowvol-
ume.
1 Press M.C. toselect the desiredsetting.
OFF (off)—LOW(low)—MID (mid)—HI (high)
SUB.W (subwooferon/off setting)
This unitis equipped witha subwoofer output
which canbe turned on oroff.
1 Press M.C. toselect the desiredsetting.
NOR (normalphase)—REV (reverse phase)—
OFF (subwooferoff)
SUB.W CTRL(subwoofer adjustment)
Only frequencieslower than thosein the selected
range areoutputted from thesubwoofer.
1 Press M.C. todisplay the settingmode.
2 Press M.C. tocycle between thefollowing:
Cut-off frequency—Outputlevel—Slope level
Rates thatcan be adjustedwill flash.
3 TurnM.C. to selectthe desired setting.
Cut-off frequency: 50HZ—63HZ—80HZ—
100HZ—125HZ—160HZ—200HZ
Output level:–24 to +6
Slope level:–6— –12
BASS BOOST(bass boost)
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to selecta desired level.
0 to+6 is displayed asthe level isincreased or
decreased.
HPF SETTING(high pass filteradjustment)
When youdo not want lowsounds from thesub-
woofer outputfrequency range toplay from the
front orrear speakers, turn onthe HPF (highpass
filter). Onlyfrequencies higher than thosein the
selected rangeare output fromthe front or rear
speakers.
1 Press M.C. todisplay the settingmode.
2 Press M.C. tocycle between thefollowing:
Cut-off frequency—Slopelevel
3 TurnM.C. to selectthe desired setting.
Cut-off frequency: OFF—50HZ—63HZ—80HZ
—100HZ—125HZ—160HZ—200HZ
Slope level:–6— –12
SLA (sourcelevel adjustment)
SLA (Sourcelevel adjustment) letsyou adjust the
volume levelof each source toprevent radical
changes involume when switchingbetween sour-
ces.
! Settings arebased on theFM volume level,
which remainsunchanged.
! The AMvolume level canalso be adjusted with
this function.
! When selectingFM as thesource, you cannot
switch toSLA.
! USB, iPodand PANDORA are allset to the
same settingautomatically.
1 Press M.C. todisplay the settingmode.
2 TurnM.C. to adjustthe source volume.
Adjustment range:+4 to –4
System menu
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select SYSTEM.
3 Turn M.C. to select the system menu
function.
Once selected, the following system menufunc-
tions can be adjusted.
! INFO DISPLAYis not availablefor DEH-
4500BT.
CLOCK SET(setting the clock)
1 Press M.C. todisplay the settingmode.
2 Press M.C. toselect the segmentof the clock
display youwish to set.
Hour—Minute
3 TurnM.C. to adjustthe clock.
12H/24H (timenotation)
English
Operating this unit
13
Section
Operating this unit
En
02
<QRD3123-A/N>13