Filter
Top Products
M
O
D
E
CQ-R223W
DOLBY B NR
D
IS
P
TRACK
TUNE
REMOTE
LO
U
D
MONO
MUTE
DISC SCAN REPEAT RANDOM
APM
B
A
N
D
PWR
V
O
L
/
P
U
S
H
S
E
L
1
MTL NR
25
B•S
63
TPS REP
4
MUTE
D
IS
P
PWR
E
N
G
L
I
S
H
2
Clock Setting
CQ-R223W
13
E
N
G
L
I
S
H
1
CQ-R223W
12
General
Power
Turn the key in the ignition until the accessory indicator lights.
Power on: Press [PWR].
Power off: Press [PWR] again.
ACC
ON
Volume level (0 to 40)
Volume
Turn the knob clockwise to increase volume,
and counterclockwise to decrease volume.
Mute
Press [MUTE] to mute the sound completely.
Press
[MUTE] again to cancel.
Loudness (LOUD)
Press and hold for more than 2 seconds [MUTE]
(LOUD) to enhance bass and treble tones at low or
medium volume.
Press and hold for more than 2 seconds
[MUTE]
(LOUD) again to cancel.
M
O
DE
CQ-R223W
DOLBY B NR
D
IS
P
TRACK
TUNE
REMOTE
LO
U
D
MONO
MUTE
DISC SCAN REPEAT RANDOM
APM
B
A
N
D
PWR
V
O
L
/
P
U
S
H
S
E
L
1
MTL NR
25
B•S
63
TPS REP
4
D
IS
P
TRACK
TUNE
Audio Mode
(Bass/Treble/Balance/Fader)
The 24-hour system is used for the clock.
q
Push [SEL] to select the audio mode.
Volume Bass Treble
BalanceFader
[] TUNE], [[ TUNE](Hours, minutes)
w
Hours
w Press and hold [DISP] (clock) for more than 2
seconds.
Initial Time
q Press [DISP] (clock).
(Hours blink.)
e Press []TUNE] or [[ TUNE].
(Hours set.)
Minutes
r Press [DISP] (clock).
(Minutes blink.)
t Press []TUNE] or [[ TUNE].
(Minutes set.)
y Press [DISP] (clock).
Note: Press and hold [] TUNE] or [[ TUNE] to
change numbers rapidly.
Time Reset
Press and hold [DISP] (clock) for more than
2 seconds to activate the time setting mode to reset
the time.
Then, repeat steps
ቤ to ቧ.
(End.)
“AdJ” is displayed when the
clock is not adjusted.
Turn
[VOL] (volume) clockwise or counterclockwise to
change each level.
Bass:
Adjustable range: –12 to + 12 dB (by 3 dB step)
Treble:
Adjustable range: –12 to +12 dB (by 3 dB step)
Balance:
Adjustable range:
1 to 15 (by 1 dB step)
Balance center
(default)
R (right speaker) or L (left speaker)
Fader:
Adjustable range:
1 to 15 (by 1 dB step)
Fader center
(default)
F (front speaker) or R (rear speaker)
Up
Down
push
Note: If no operation takes place for more than 5 seconds in
audio mode (2 seconds in volume mode), the display returns
to the regular mode.
[DISP] (display)
Mute indicator
Loudness indicator
default: 0 dB
default: 0 dB
Remote control sensor (REMOTE) (➡ page 20)