Filter
Top Products
1
2
3
4
Mounting spring (L)
E
N
G
L
I
S
H
12
CQ-R223W
23
E
N
G
L
I
S
H
11
Installation (Continued)
CQ-R223W
22
Cautions:
• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
fingers.
Establish the rear of the unit.
After fixing Mounting Bolt t connection and
Power Connector
y, fix the rear of the unit to the
car body by either method (a) or (b) shown on the
previous page.
Insert Trim Plate i.
After installation reconnect the
negative (–) battery terminal.
First complete the electrical connections, and
then check them for correctness.(
a page 25)
Insert Mounting Collar q into the
dashboard, and bend the mounting
tabs out with a screwdriver.
The included Mounting Collar
q is designed specially for this
unit. Do not use it to attach any
other model.
y Power Connector
Engage Mounting
Springs (
C) in the both
sides of the mounting
holes of Mounting Collar
q firmly.
Mounting Spring
Mounting
Hole
Tab
q Mounting
Collar
Mounting Springs (R)
Mounting Holes
t Mounting Bolt
The tabs to be bent vary depending on the car.
To securely install the unit, fully bend a
number of the tabs so that there is no rattling.
Example:
To Remove the Unit
Switch off the power of the unit.
Remove the removable face plate.
ᕡ
Press []. (release button). The
removable face plate will be released.
1
Remove the Trim Plate i with a screwdriver.
2
ᕡ
Insert the Dismounting Plates u along the
grooves on both sides of the main unit
until “click” is heard.
ᕢ
Pull out the unit while pushing the plates
further inside.
3
Remove the unit pulling with both hands.
4
C
Q
-
R
2
2
3
W
D
O
L
B
Y
B
N
R
Push ᕡ
Contact
i Trim Plate
Screwdriver
ᕡ
ᕢ
u Dismounting Plate
Insert
Pull out
MODE
NR
TUNE
REMOTE
Release button
Insert the tab
end in the
outer groove.
“Click”
ᕡ
ᕢ
ᕢ