Oricom C1000 1.8 GHz Headphones User Manual


 
11
Phone Key
Key Function Key
Phone Book
Service
Recall
Recall
Redial / Program
Clear / Number
Up
Down
Phone On/Off
Mute
Ringer On/Off
Dial Tone
Pause
12
Basic Steps For Installation
1. Set up the base and POD on a flat, stable surface.
2. Connect the output plug of the base adaptor to the
socket on the
bottom of the base unit and the adaptor to the main wall outlet. The power
LED on the base should become steadily lit.
3. Connect one end of the telephone line to the
socket on the bottom of
the base unit and the other end to the wall phone socket.
4. Remove the battery cover on the base of the pod and insert the battery pack
(supplied with the unit), observing the correct orientation of the plug with the
connector. Relocate the battery compartment door.
5. Connect the output plug of the POD adaptor to the
socket on the top
of the POD unit and the power adaptor to power socket. Allow the battery to
charge for at least 15 hours before first use.
CAUTION
Use only the power adaptors supplied with this product. Incorrect adaptor
polarity or voltage can seriously damage the unit.
For Base: For POD:
Input: 240 VAC 50 Hz Input: 240 VAC 50 Hz
Output: 7 VDC 400 mA Output: 12 VDC 500 mA
Polarity: Center positive Polarity: Center positive
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
Refer to the original type supplied with this telephone. Ni-MH batteries must be
disposed of in accordance with applicable waste disposal regulations.
Charging the POD
If the battery icon flashes or the LED’s on the POD flashes RED periodically
during phone mode, the battery pack needs recharging. Connect the POD to the
AC adaptor plugged to the main wall outlet to start charging.
Note: POD shall take 30 seconds to power up when the adaptor is connected to
a flat battery pack.
To Ensure Better Performance
1. Locate the conference telephone in a quiet environment.
2. Position the POD within 30 metres of the base unit.
3. Do not use the POD with the other phone in a single room.
4. Do not move the POD during a call.