Filter
Top Products
2. Tune to the station you want to store.
3. Hold down the desired memory location button until the frequency, ME,
and band and memory group appear on the display. The volume
momentarily mutes while the radio stores the station.
Automatically Storing Stations
1. Repeatedly press BAND to select the band and memory group where you
want to store stations. For example, to store the first group of AM
stations into AM 1, press BAND until AM 1 appears.
2. Hold down AMS (automatic memory scan) for about 3 seconds. The stereo
scans the selected band and stores the first six stations it finds
(starting with the currently tuned frequency).
During the scan, the stereo only searches for strong stations, and LOC
appears on the display. If the stereo does not find six strong
stations, it scans again, searching for weaker stations, and LOC
disappears from the display.
The band and memory group, frequency, and ME appear on the display.
Then, after the stereo stores six stations or scans the band twice, it
tunes to the first stored station and begins to play.
3. To stop searching for stations before it automatically stops, briefly
press AMS.
Note: If a station has a weak signal or interference, the stereo might
not store it automatically. If this happens, you can manually
store the station.
Selecting a Stored Station
To select a stored station, press BAND to select the correct memory group.
Then briefly press the desired memory location button. (Do not hold down
the memory location button. This erases the previously stored station and
stores the currently tuned station into that location.)
Scanning Stored Stations
The stereo's automatic memory scan (AMS) feature scans all stored stations
in a memory group you select, pausing for 5 seconds at each stored station
1. Press BAND until the stereo displays the memory group you want to scan